790020

Inventum VWM9001 Manual

39
Zoom out
Zoom in
Previous page
1/116
Next page
English •39
LEVELLING THE APPLIANCE
Use a water level and spanners No. 32 (for feet) and 17 (for the nut).
1. Level the washing machine in longitudinal and traverse
direction byscrewing the adjustable feet up or down.
2. After adjusting the height of the feet, firmly tighten the jam
nuts (counter nuts) using a spanner No 17, by turning them
towards thebottom of the washing machine (see figure).
i
Incorrect levelling of the washing machine with the
adjustable legsmay cause vibration, appliance moving across
the room, and loud operation.
Incorrect levelling of the washing machine is not subject to
warranty.
Sometimes, an unusual or louder noise may appear during
appliance operation; these are mostly the result of improper installation.
CONNECTING THE WATER SUPPLY HOSE
WARNING! To prevent leakage or water damage, follow the instructions in this chapter. Make sure not to kink, crush or
modify the water supply hose.
Tighten the water supply hose by hand, firmly enough for the hose to have a good seal. After connecting the hose, the
seal must be checked for any leaks. Do not use pliers or similar tools when connecting the water supply hose as this could
damage the nut thread.
1. Connect the water supply hose to the water inlet valve on
the back ofthe appliance.
2. Connect the other end of the water supply hose with the
aqua stop toa water tap with cold water.
CONNECTING THE WATER DISCHARGE HOSE
WARNING!
• Make sure not to kink or stretch the water discharge hose.
• Connect the water discharge hose properly, otherwise it could result in damage or water leakage.
Feed the water discharge hose into a drain pipe, wash basin or floor drain. Be careful not to feed the water discharge hose
too deep in the drain. Otherwise the waste water cannot flow freely. The vertical distance from the floor to the end of the
discharge hose may be no more than 100 cm and no less than 60 cm.
1. Put the water discharge hose in a floor drain. 2. Connect the water discharge hose to a drain pipe.
Max. 100 cm
Min. 60 cm
Max. 100 cm
Min. 60 cm
Max. 100 cm
… 39 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum VWM9001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum VWM9001 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1.6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info