790027

Inventum VR550B Manual

22
Zoom out
Zoom in
Previous page
1/56
Next page
reversing the door opening
It is possible to change the door opening from either the left or the right side. To change the opening direction, please follow
these instructions.
Note: Before reversing the door swing, set the thermostat on OFF and unplug the appliance from the mains. Empty the
appliance, including the shelves before reversing the door opening.
• Remove the two screws at the back, holding the top panel to the appliance.
• Lift the top panel and remove it.
• Remove two bolts from the left top side and remove from the right top side the hinge with the three bolts (mind the
plastic parts between the hinge and the door).
• Remove the door by carefully lifting it from the bottom hinge. Put the door in a safe place.
• Remove and fit the plastic nog from the right side to the left side.
• Tilt the appliance 45°.
• Unscrew the two bolts and remove the bottom hinge. Install the bottom hinge on the opposite side und replace the bolts
in the provided holes.
• Replace the front leg on the right side with the bolts.
• Place the door against the appliance and make sure it is well fitted on the bottom hinge.
• Refit the hinge on the left top side (mind the plastic parts) with the bolts. Make sure the door is alligned with the outside of
the appliance.
• Set the appliance carefully upright.
• Screw the bolts back on the right top side.
• Remove the plastic part from the inside of the top panel and place it on the opposite side.
• Refit the top panel using the screws.
• Leave the appliance to stand for at least 3 hours before you insert the plug into the socket.
8
22 • English
troubleshooting
7
Problem Cause Solution
Appliance is not functioning Appliance is not plugged in Plug the appliance in the socket
Temperature inside the
larder is too high or too low
Thermostat has been set incorrectly Set the thermostat correctly
Air circulation vents are blocked Clean the ventilation openings
Appliance is excessively noisy Has the appliance been installed correctly? Check the installation
Are the pipes at the back touching or
vibrating?
Check it and move the appliance
forwards
During normal use of the cooling appliance, different types of noises can occur that do not have any effect on the correct
operation of the appliance.
Noises that can be easily remedied:
• Noise due to the fact that the appliance is not level – position the appliance using the front adjustable feet. If necessary,
placesoft material under the rear wheels, particular in case of a tiled floor.
• Friction against other furniture – move the appliance.
• Grinding of drawers or shelves – remove the shelf or drawer and then place it back.
• Noise of colliding bottles – place the bottles apart.
Noises that can be heard during normal use of the appliance are caused by the operation of the thermostat, compres-
sor (activation), cooling system (shrinkage and expansion of the material under the influence of temperature differences
andflow of cooling liquid).
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum VR550B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum VR550B in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0.78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info