694949

Inventum NB450 Manual

13
Zoom out
Zoom in
Previous page
1/32
Next page
using the mixer
4
English • 13
cleaning & maintenance
6
Before plugging into a socket, check that the voltage in your home corresponds with the voltage printed on the bottom of the
appliance.
1. Place the mixer on a flat, clean and dry surface.
2. Make sure that the mixer is not activated.
3. Place the ingredients in the jug and lock it with the lid. Place the jug with the handle on the right side onto
the base and turn it clockwise, until you feel it click into place.
4. Activate the mixer by choosing a speed setting.
Attention: Do not activate the mixer constantly, this can cause engine problems. Do not use the mixer for
more then 1 minute continuously, wait 1 minute before you operate it again.
5. When the mixer has finished mixing, blending or crushing turn the control button OFF (0) and wait until
the knives have stopped turning, before you remove the jug.
tips
5
• When the jug is cracked, do not use the mixer anymore. This could lead to damage while using the mixer.
• To avoid splashes always place the lid on the jug.
• Always add liquid ingredients before adding solid ingredients in the mixer.
• The mixer mixes best when you do not add pieces which are too large.
• Always add a half a cup of liquids when you crush ice cubes.
• To add ingredients while the mixer is activated, take the cap out of the lid and add the ingredients through the opening.
• When the ingredients stick to the sides of the jug or are not mixed properly, shut off the engine: wait until the knives have stopped
turning and push the ingredients with a spatula towards the knives.
• To prevent the ingredients from being blend to small, take into account that the mixer mixes in seconds, not minutes!
• Working with warm ingredients can cause a build-up of pressure in the jug and that can cause hot liquids to escape when you take
the lid of the jug. Therefore always remove the cap from the lid when you are processing warm ingredients.
Always unplug the cord from the socket before cleaning the appliance.
• Wipe the base with a damp cloth. Do not use any abrasive or strong detergents.
• Never place the appliance, the power cable or the plug in water or any other liquid.
• Remove the knives according to the instructions below. Be careful, the knives are extremely sharp. Clean the knives as a whole do
not try to take them apart. Attention: do not use any abrasive or strong detergents.
• For placing and removing the knives you need the glass jug and the knives. Place the glass jug, without the lid, upside down on a flat
stable surface. Put your thumb and forefinger in the middle plastic ring and loosen it clockwise. Now take the knive assembly and
the silicone ring out of the blender. Attention: never try to take the knive assembly apart.
To replace the knives follow the instructions in the reverse order. Make sure not to forget to place the silicone ring. The blender will
leak without the silicone ring.
• The following parts can be cleaned: the jug, the knive assembly, the lid and the cap. Be careful when cleaning the knive assembly.
The knives are very sharp.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum NB450 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum NB450 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info