616180

Inventum MK351 Manual

10
Zoom out
Zoom in
Previous page
1/24
Next page
appliance description
2
10 • English
before first use
3
preparing milk foam
4
heating milk
5
1. Lid with sealing ring
2. Handle
3. Controllights (blue/red)
4. Start button for heating and frothing
5. Base
6. Maximum indication for heating milk - MAX
7. Maximum indication for frothing milk - MAX
8. Whisk (frothing)
9. Mixer (heating)
6
7
8 9
Before you use the appliance for the first time, please do
as follows: Carefully unpack the appliance and remove all
the packaging material. Keep the material (plastic bags and
cardboard) out of reach of children. Check the appliance after
unpacking for any visible damage, possible from transportation.
Place the appliance on a stable and heat resistant surface.
Clean the lid, the whisk and the mixer with warm soapy
water. Dry the parts thoroughly. Make sure that the parts are
completely dry.
Wipe the exterior and interior with a soft damp cloth and dry
thoroughly. The appliance is only suitable heating and frothing
milk. Never fill the appliance with other drinks.
Check that the voltage in your home corresponds with the
voltage printed on the bottom of the appliance and plug
the appliance in.
Lift the lid and fit the whisk in the jug. Fill the desired amount of
milk into the jug. Do not exceed the maximum of the lower max.
mark - MAX
- 115 ml. Frothed milk expands and causes the
pitcher to overflow, if filled up too high. The minimum capacity
is 50 ml.
Put the lid back on the jug and place the appliance on the base.
Start the preparation by pushing the button. The control lights
(blue/red) will burn and the whisk will start turning. Depending on
the filling volume, the preparation stops automatically after ca.
90 seconds. The blue control light goes out and the red light will
blink for about 30 seconds to indicate the milk frother is ready.
After the preparation is completed, remove the lid upwards and
pour or ladle the milk foam into a cup or bowl. Do not remove
the foam with a spoon or other metal object. This will damage
the coating.
After having used the frother, clean the appliance as described
in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 minutes before using it
again or rinse it with cold water. The milk frother will be faster
ready to use it again.
TIPPS
• The best result is achievement when using whole milk.
• If the amount of milk of too low the result will not be good -
less than 50 ml.
Lift the lid and fit the mixer in the jug. Fill the desired amount of
milk into the jug. Do not exceed the maximum of the top max.
mark - MAX
- 240 ml.
Put the lid back on the jug and place the appliance on the
base. Start the preparation by pushing the start button. The
control lights (blue/red) will burn and the mixer will start
turning. Depending on the filling volume, the preparation stops
automatically after 100 to 120 seconds. The blue control light
goes out and the red light will blink for about 30 seconds to
indicate the milk frother is ready.
After the preparation is completed, remove the lid upwards and
pour the hot milk into a cup. After having used the appliance,
clean it as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 minutes before using it
again or rinse it with cold water. The milk frother will be faster
ready to use it again.
2
4
5
1
3
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum MK351 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum MK351 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info