616190
15
Zoom out
Zoom in
Previous page
1/20
Next page
cleaning & maintenance
7
Before cleaning the appliance set the thermostat to OFF and
always unplug the appliance.
Clean the interior of the appliance. Use warm water and a
neutral detergent to prevent any bad smells occurring. After
cleaning, rinse the interior with clean water and rub dry. Leave
the appliance to dry for 1 to 2 hours. Simply remove the shelves,
drawer and door compartments to clean them by hand. Do not
clean the interior accessories in the dishwasher.
Clean the outside of the appliance and the gasket with a soft
moist cloth.
REPLACING THE BULB
When replacing the bulb, proceed as follows:
Unplug the appliance from the mains.
Remove the lamp cover.
First check if the bulb is fully screwed in.
If the bulb is defective, replace it with a bulb of the same
type: maximum 15 Watt, socket E14. This kind is widely
available.
Replace the cover.
Plug the appliance back into the mains.
troubleshooting
8
Problem Cause Solution
Appliance is not
functioning; light
does not work
Appliance is not
plugged in
Plug the
appliance in the
socket
Temperature
inside the
refrigerator is too
high or too low
Thermostat has
been set
incorrectly
Set the
thermostat
correctly
Air
circulation vents
are blocked
Clean the
ventilation
openings
Appliance is ex-
cessively noisy
Has the
appliance been
installed
correctly?
Check the
installation
Are the pipes at
the back touch-
ing or vibrating?
Check it and move
the
appliance
forwards
Note: gurgling and hissing noises due to expansion in the
refrigerant circuit are normal.
reversing the door opening
It is possible to change the door opening from either the left or
the right side. To change the opening direction, please follow
these instructions.
Note: Before reversing the door swing, set the thermostat
on OFF and unplug the appliance from the mains. Empty the
appliance, including the shelves before reversing the door
opening.
Remove the two screws at the back, holding the top panel
to the appliance.
Lift the top panel and remove it.
Remove two bolts from the left top side and remove from the
right top side the hinge with the three bolts (mind the plastic
parts between the hinge and the door).
Remove the door by carefully lifting it from the bottom hinge.
Put the door in a safe place.
Remove and fit the plastic nog from the right side to the left
side.
Tilt the appliance 45°.
Unscrew the two bolts and remove the bottom hinge. Install
the bottom hinge on the opposite side und replace the bolts
in the provided holes.
Replace the front leg on the right side with the bolts.
Place the door against the appliance and make sure it is well
fitted on the bottom hinge.
Refit the hinge on the left top side (mind the plastic parts)
with the bolts. Make sure the door is alligned with the outside
of the appliance.
Set the appliance carefully upright.
Screw the bolts back on the right top side.
Remove the plastic part from the inside of the top panel and
place it on the opposite side.
Refit the top panel using the screws.
Leave the appliance to stand for at least 3 hours before
you insert the plug into the socket.
9
English 15
Clean and dry the freezer comparment. Switch the thermostat
on to the right setting. When the freezer compartment reaches
its correct temperature, replace the food items.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum KV550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum KV550 in the language / languages: English, Dutch as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info