704955

Inventum KV1800NF Manual

22
Zoom out
Zoom in
Previous page
1/56
Next page
troubleshooting
7
Breakdown Cause Solution
Appliance does not do anything;
led does not light up
Plug not in socket Insert the plug in the socket.
Temperature in the refrigerator is
too high or too low
Incorrect thermostat setting - Set the thermostat to the correct position
- Check whether the MIN or MAX position
has been set for the freezer section.
Ventilation openings are blocked Clean the ventilation openings
Appliance makes noise Is the appliance properly installed? Check the installation
Does the rear of the refrigerator make
contact with something?
Check this and move the refrigerator
forward
Remark: bubbling and expansion noises in the cooling circuit are normal.
reversing the door opening
8
The doors of the appliance can be opened on the right or left side. In order to reverse the door opening, observe the
instructions below. It would be best to do this with two people.
Attention: remove the plug from the socket. Remove all items from the refrigerator, including the shelves, before reversing
the door opening.
• Remove the protective cover on the hinge - fig.1.
• On the right top side, remove the hinge with the three bolts (do take note of the plastic adapter bushes between the
hinge and the door) - fig.2. On the left top side of the appliance, remove the two bolts.
• Carefully remove the upper door by moving it towards you and lifting it off the middle hinge. Place this door on a safe
location - fig. 3.
• Remove the middle hinge on the right side by loosening the two bolts and put it aside for the moment. Immediately
move the white protective caps from the left to the right side and place them on the location where the middle hinge was
removed - fig. 4.
• Carefully remove the bottom door by moving it towards you and lifting it off the bottom hinge - fig. 5. Place this door on a
safe location.
• At the bottom side of the door, move the plastic block from the right side to the left side.
• Then tilt the refrigerator backwards by maximum 45°.
• On the left bottom side, remove the adjustable foot and the two bolts.
• On the right bottom side, remove the hinge and the three bolts - fig. 6. Then place the hinge on the left bottom side with
the bolts.
• Place the adjustable foot on the right bottom side and re-insert the bolts there as well.
• Place the bottom door against the appliance and make sure the bottom side is properly placed on the bottom hinge.
Make sure the door is straight in relation to the exterior of the refrigerator.
• Now mount the middle hinge and accompanying bolts on the left side - fig. 7. Make sure the hinge is placed in the top side
of the bottom door. Use the adapter bushes and tighten the bolts. The bottom door has now been mounted.
• Now place the upper door against the appliance and make sure the bottom side is properly placed on the middle hinge.
• On the left top side, place the hinge with plastic adapter bushes and fasten it with the bolts - fig. 8. Make sure the door is
straight in relation to the exterior of the refrigerator.
• Carefully place the appliance upright again.
• On the right top side, screw the bolts back in the appliance.
• Place the protective cover back on the upper hinge.
• Allow the appliance to rest for 2 to 3 hours before inserting the plug in the socket.
22 • English
… 22 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum KV1800NF at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum KV1800NF in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info