694974

Inventum KP602 Manual

13
Zoom out
Zoom in
Previous page
1/28
Next page
Before using the appliance for the first time, you should proceed as follows: carefully unpack the hob and remove all packaging
material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the reach of children.
Afterunpacking the appliance, check it for external damage that may have occurred during transport.
Place the hot plate on a sturdy, flat and heat-resistant surface. Clean the hot plate with a slightly damp cloth. The cook plate(s)
is/are provided with a protective layer that must be removed prior to first use. This is done by turning on the cook plate
atmaximum level for approximately 4 to 5 minutes. Light smoke may form due to the protective layer burning off the cook plate.
After removing the protective layer you can switch off the cook plate or start using it.
Make sure the thermostat button is on the «OFF» position before the appliance is switched on. Insert the plug in the socket.
Turn the thermostat knob to the right, to the required position. The accompanying indicator led will light up.
Position «MIN» of the cook plate is the lowest position and position «MAX» is the highest position.
Use a low position [ MIN to 4 ] for simmering and a higher position [ 5 tot MAX ] for boiling and frying.
The thermostat button is a stepless control.
OFF = off
MIN = low
1-4 = keep warm-simmer
5 = boiling and frying
MAX = high
It takes approximately 10 minutes for the cook plate to reach maximum temperature (on the maximum setting of the thermostat knob).
When the temperature that belongs to the set position is reached, the indicator led switches off. After a drop in temperature,
heattransfer to the pan, the thermostat switches on again. The indicator led will light up again.
Due to the construction of the hot plate, it remains hot for some time after switching off. This residual heat can be used to keep
the food warm for a short period of time.
CAUTION: THE APPLIANCE CAN GET VERY HOT DURING USE, THEREFORE PLACE THE APPLIANCE DURING USE ON A HEAT-
RESISTANT PLATE AND NEVER, FOR EXAMPLE, ON A PLASTIC TABLE, PLASTIC TABLE CLOTH OR REFRIDGERATOR.
Only use pans with bottoms that have the same diameter as the hot plate itself. Smaller diameters lead to loss of energy.
Do not touch the hot plate when it is switched on. Please note that the hot plate does not cool down immediately after being
switched off. Turn the thermostat button to the «OFF» position to switch off the hot plate and after each use, remove the plug
from the socket.
prior to first use
3
use
4
Prior to cleaning, always switch off the appliance and remove the plug from the wall socket. Allow the hot plate to cool down
before cleaning it with a damp cloth.
The base unit can also be cleaned with a damp cloth or sponge. Do not use abrasives or other aggressive cleaning agents.
Do remember that the hot plates require some time to cool down after having been switched off.
Do not submerge the appliance in water and/or other liquids.
cleaning and maintenance
5
English • 13
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum KP602 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum KP602 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info