616192
15
Zoom out
Zoom in
Previous page
1/24
Next page
tips
5
High ambient temperatures have a negative effect on energy
use. Keep the larder in a position away from direct sunlight or
other sources of heat.
Keep ventilation openings free. Clogged openings lead to
higher use of energy.
Try not to open the door too often, especially when the
weather is wet and hot. Once you open the door, mind to
close it as soon as possible.
The space between the shelves and the rear wall of the larder
compartment must be unobstructed to allow the cool air to
circulate. Therefore don’t place any food items against the
back.
Turn the thermostat to a lower setting when the
circumstances allow it.
Before storing fresh cooked food, make sure the food has
cooled at least to room temperature.
If the gasket is damaged or if it turns out that the sealing is
poor, the energy consumption is substantially higher. To
restore efficiency, replace the gasket.
Keep the condensor on the rear wall always clean, free of
dust or any impurities.
Always consider the instructions, otherwise the
energyconsumption is substantially higher.
English 15
cleaning & maintenance
6
Before cleaning the larder always unplug the appliance. Clean
the interior of the appliance. Use warm water and a neutral
detergent to prevent any bad smells occurring. After cleaning,
rinse the interior with clean water and rub dry. Leave the
appliance to dry for 1 to 2 hours. Simply remove the shelves,
drawer and door compartments to clean them by hand. Do not
clean the interior accessories in the dishwasher.
Clean the outside of the larder and the gasket with a soft moist
cloth.
We recommend that you dus the back of the appliance with a
cloth or vacuum cleaner once a year in order to maintain a good
output and low energy consumption.
Defrosting of the larder compartment is completely
automatic.
Droplets of water on the rear wall of the larder compartment
indicate that the periodic automatic defrost cycle is in progress.
The defrost water is automatically routed to a drain outlet and
into a container from which it evaporates.
REPLACING THE BULB
When replacing the bulb, proceed as follows:
Unplug the appliance from the mains.
Remove the lamp cover by unscrewing the screw and pull the
lamp cover towards you.
First check if the bulb is fully screwed in.
If the bulb is defective, replace it with a bulb of the same
type: maximum 10 Watt, socket E14. This kind is widely
available.
Replace the cover and the screw.
Plug the appliance back into the mains.
troubleshooting
7
Problem Cause Solution
Appliance is not
functioning; light
does not work
Appliance is not
plugged in
Plug the
appliance in the
socket
Temperature
inside the
larder is too high
or too low
Thermostat has
been set
incorrectly
Set the
thermostat
correctly
Air
circulation vents
are blocked
Clean the
ventilation
openings
Water is running
out of the
larder
Drain outlet is
blocked
Clear the drain out-
let with a skewer
Appliance is ex-
cessively noisy
Has the
appliance been
installed
correctly?
Check the
installation
Are the pipes at
the back touch-
ing or vibrating?
Check it and move
the
appliance
forwards
The inside light is
not working
Lamp is
defective
Replace the bulb
following the
instructions
Note: gurgling and hissing noises due to expansion in the
refrigerant circuit are normal.
KK552-KK601-instructions-0115.indd 15 26-1-2015 14:01:24
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum KK552 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum KK552 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info