616213
33
Zoom out
Zoom in
Previous page
1/40
Next page
THE FITTING OF THE APPLIANCE
Check that the cabinet and the cut-out meet the dimension and ventilation requirements.
Remove the chips from the cutting job in the opening of the worktop and treat the saw ends of wooden or synthetic worktops with
sealing varnish if necessary, to prevent moisture causing the worktop to swell.
Lay the hob upside down on the worktop.
Fit the connecting cable to the appliance in compliance with requirements.
Remove the protective layer from the sealing tape and apply the tape on the edge of the glass plate. Make sure to apply the tape
to the glass and not on the metal part. Do not stick the tape around the corners, but cut 4 separate pieces to seal the corners well.
Attention: any damage that occurs when not applying the tape has concequences for the warranty.
Fit the supllied mounting brackets on the appliance.
Turn the hob over and lay it in the recess.
Connect the appliance to the mains. The appliance is ready for use.
Check that it works properly. If the appliance has been wrongly connected either a bleep will sound or an error code will appear on
the displays.
REMOVING THE HOB
Disconnect the hob from the mains. Remove the hob by pushing it upwards from the bottom. Attention! Beware of damage to the
appliance! Do not try to remove it from the top.
ELECTRICAL CONNECTION FOR 60 AND 78 CM WIDE HOBS
Connect the hob according to the wiring diagram.
This device is set for 2 x 1 phase (230V DC) and uses a so-called
5-pin Perilex plug. These groups in the meter must be secured
with at least 16 amps each. The connection cable must have a
cross-section of at least 2.5 mm ².
ATTENTION
:
this hob is not suited for a different wiring
diagram.
5x2,5 mm²
L1-N1 L2-N2
220V 220V
240V 240V
5x2,5 mm² 3N~
Model: IKI6020
IKI6021
IKI6022
IKI6023
IKI7821
Model: IKI9021
ELECTRICAL CONNECTION FOR A 90 CM WIDE HOB
Connect the hob according to the wiring diagram.
This device is set for three phase, three phase (400V DC) and
uses a special 5-pin plug. The connection cable must have a
cross-section of at least 2.5 mm ². The connection must be
performed by a qualified installer.
ATTENTION
:
this hob is not suited for a different wiring
diagram.
English 33
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum IKI6023 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum IKI6023 in the language / languages: English, Dutch as an attachment in your email.

The manual is 2,1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info