616176

Inventum GF626 Manual

10
Zoom out
Zoom in
Previous page
1/24
Next page
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after unpacking for any visible
damage, possible from transportation. Place the appliance on a stable and heat resistant surface.
Open the lid by pushing the open button. Remove the lid by pulling it straight up from the fryer. Remove the basket.
Wipe the exterior of the fryer and the reservoir only with a damp cloth and dry thoroughly.
Clean the lid and the basket in the dishwasher. Ensure that the parts are dried thoroughly before use. Place the lid back on the fryer.
Fill the reservoir with frying fat to a level between the minimum and maximum level, ca. 2.5 liters. The frying fat can never be under or
over the minimum or maximum level. Inside the reservoir you find the two lines indicating the minimum and maximum level.
If you wish to use solid fat, cut the blocks to small pieces. Turn the fryer on with the on/off button, position 1, and set the thermostat to
150°C. Wait until the solid fat is melted and check the level. Adjust the thermostat to the desired temperature.
appliance description
2
before the first use
3
frying
4
10 • English
• Place the fryer on a stable and heat resistant surface and plug it in.
• Turn the fryer on with the on/off button, position 1. The red thermostat lamp will light up.
• Turn the thermostat button to the right to the desired temperature. On the fryer only 150°-170°-190° are indicated. The markings
around the thermostat button correspond each with an increase of 10 degrees.
• As soon as the desired temperature is reached, the green controllamp goes out. The thermostat and the thermostatlamp will
toggle On and Off as the thermostat in the fryer maintains the correct temperature.
• The fryer is now ready to use.
• Fold out the handle, make sure it lockes and take the basket out of the fryer.
• Add the desired quantity of food to the basket. Do not add too much food at one time (never more than 2/3). Food should be as dry
as possible ot reduce the amount of water getting into the oil. Shake the ice off of frozen products above the sink.
• Lower the basket slowly into the oil. If you lower too fast, the oil can splash.
• Close the lid properly.
• Push the button to lower the handle back down in the housing of the fryer.
• When the food is fried, open the lid with the open button. Be carefull: the damp is hot.
• Fold out the handle, make sure it lockes and lift the basket out of the oil. Carefully shake the excess fat of and hang the basket with
the holding lug to the edge of the reservoir to drain away the oil.
• Take the basket out of the fryer and serve the food.
• Place the basket back and close the lid.
1. Window
2. Filter
3. Basket with foldable handle
4. Thermostat button
5. Handle notch
6. On/off button
7. Control light - power
8. Control light - thermostat
9. Lid OPEN button
10. Reservoir with non-stick coating
11. Lid
11
1
2
3
4
9
8
5
6
7
10
2
7
4
1
6
3
8
9
2
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum GF626 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum GF626 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info