704971

Inventum AS010 Manual

27
Zoom out
Zoom in
Previous page
1/60
Next page
troubleshooting
8
Problem Solution
Appliance is not functioning Check that the appliance is switched on.
Check that there has not been a power cut.
Check that the plug is not faulty.
Check that the fuse has not blown.
Check that the voltage is correct for the appliance.
Are there any faults with the socket? For this purpose, try the plug of your appliance by
connecting it to a socket which you are sure is working.
Temperature inside the appliance is
not cold enough
Check that there is not too much food in the appliance.
Check that the temperature is set to a suitable temperature.
Check that the appliance is not placed in direct sunlight, or too near to a heating source.
Check that the ambient temperature is within the operation limits of the appliance.
Are the doors of the appliance opened frequently? Once the door is opened, the
humidity found in the air in the room enters the appliance, especially if the humidity
levels in the room are very high. The more frequently the door is opened in humid
conditions the more chance of the build up of moisture.
Temperature inside the
appliance too cold
Increase the working temperature by adjusting the temperature to a higher level.
The lowest setting/temperature should only be used as a rapid cool setting and
should only be set 2 hours before a large amount of food is placed in the fridge. If this
is not done the temperature in the fridge compartment could fall below 0°C as the
compressor will run continuously.
The inner surfaces of the appliance
are wet
Caused by condensation - dry the inside of the appliance.
The outer surfaces of the appliance
are wet
Caused by condensation - dry the outer of the appliance carefully.
The appliance smells/odour Check all the food and drink that is in the fridge is in date and correctly packaged. If it
isn’t then it should be removed immediately or repackaged.
Check for spillages on each shelf, rack and drawer. You may need to remove the
drawers to check that no spillages have settled underneath them. As spillages that have
not been cleaned and have been left can cause smells and unwanted odours.
Check the drainage pipe is not clogged or the drip tray at the back of the appliance is
full.
The doors do not close properly Ensure there are no obstructions preventing door closure.
Check the door compartments and shelves are correctly in place.
Check the door seal is not warped or torn.
Check the appliance is level.
Note: gurgling and hissing noises due to expansion in the refrigerant circuit are normal.
English • 27
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum AS010 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum AS010 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info