551578
22
Zoom out
Zoom in
Previous page
1/28
Next page
Read these installation instructions carefully before starting the installation.
Decide whether whether there is a duct available or if the cooker hood needs to recirculte. We advise to install the cooker hood
with two persons.
The minimum distance between the supporting surface for the cooking pans on the cooker and the lowest part of the hood must
be:
- 65 cm for an electric, ceramic or induction cooker
- 75 cm for a gas hob
If the cooker hood is to be fitted to an existing duct no other aplliances, such as a geyser or heater, may be
connected to that same duct.
The shorter the duct, and the fewer the bends in it, the better the cooker hood will work.
The connection pipe for the cooker hood has a diameter of 120 or 150 mm. It is best also th use a flue pipe
of the same diameter.
troubleshooting
6
What to do in case of a malfunction? In most cases, you will be able to correct these faults easily yourself. Please check the solutions
below before contacting the Inventum service department.
The motor is not running
Is it plugged in correctly?
Is there a power outage?
Check the electrical installation.
The performance of the cooker hood is not correct and makes more nois.
Is the diameter of the exhaust-air pipe correct?
Is the duct blocked?
The diameter of the duct must be 120-150 mm. A smaller diameter can negatively influence the suction of the motor.
Are the grease filters clean?
Are the carbon filters not replaced within the last 6 months? Replace the carbon filters.
Is there enough air supply to replace the extracted air?
installation instructions
7
Included for the mounting of the cooker hood:
9 pieces Ø8x40mm plugs
6 pieces M4x8mm screws
2 pieces M4x30mm screws
7 pieces M4x40mm screws
1 bracket
2 plates
BRACKET 1 for the cooker hood
PLATE 2 for the bottom part of the chimney
PLATE 3 for the top part of the chimney
Attention: the slots must be below for correct mounting
22 English
AKS6011-AKS9011-instructions.indd 22 27-8-2014 9:34:35
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum AKS9011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum AKS9011 in the language / languages: English, Dutch as an attachment in your email.

The manual is 2,19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info