616199
21
Zoom out
Zoom in
Previous page
1/28
Next page
controls
4
cleaning & maintenance
5
Before performing any maintenance operation, disconnect the cooker hood from the mains power supply. Ensure that it is
switched off and pull the plug or remove the connector fuse.
Clean the in- and outside of the cooker hood regularly. Clean the cooker hood with warm soapy water and a soft cloth. If your model
is stainless steel, clean it with a stainless steel care product. Do not use any abrasive cleaning agents such as powder cleaners or
cleaners that contain alcohol. Clean the controls only with a damp cloth.
Attention: failure to carry out the basic cleaning recommendations can cause fire risks.
GREASE FILTERS
A metal grease filter filters the fat particles in the air. Therefore the filter can get clogged, depending on the use. The metal grease filter
does not have to be replaced, but should at least be cleaned once a month. You can clean it either by hand or in the dishwasher on a
low temperature. Make sure the grease filters are competely dry before placing them back.
Do not use any abrasive cleaning agents.
Not cleaning the grease filters on time can cause fire risks.
Cleaning the grease filters in the dishwasher can cause discoloration. This has no effect on the operation.
REMOVING THE GREASE FILTER
Switch off the electricity! Remove the plug from the socket.
Pull the grease filter towards you and tilt it downwards at the front. Make sure
you guide the grease filter with you other hand to prevent the grease filter
from falling down on your cooking appliance.
CHANGING A LED SPOT
When a LED spot of the cooker hood is broken, you can replace it yourself. Follow these steps:
Unplug the appliance or remove the connector fuse.
Remove the grease filters and push the complete spot from the inside downwards - figure 1.
Unplug the broken LED from the transformer - figure 2. Replace the complete LED with a matching type (3.0 W, LED L27A).
Plug the new LED in the transformer and push the complete spot back in the housing of the cooker hood.
Replace the grease filters and plug the appliance in.
English 21
OPENING AND SHUTTING THE ELECTRIC VALVE
• Press to open the electric valve. The backlight from the buttons will light up when the electric valve is open and the cooker hood
is activated.
Press the same button to shut the electric valve. The backlight from the buttons will go out.
• Press and the lighting switches on. Press the button again to switch the lighting off.
Switch the lighting on if you need more light on your cooking appliance. It is recommended to open the valve a few minutes prior to
cooking. Leave the valve open for 5 to 10 minutes after the cooking is finished to remove all the smells from the kitchen.
1 2
12
V
3W LED
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum AKM9004 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum AKM9004 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info