551580
21
Zoom out
Zoom in
Previous page
1/28
Next page
controls
4
SWITCHING THE COOKER HOOD ON AND OFF
• Press 1 and the motor runs at the lowest speed. Press the button again to stop the motor.
• Press 2 and the motor runs at the middle speed. Press the button again to stop the motor.
• Press 3 and the motor runs at the highest speed. Press the button again to stop the motor.
• Press
and the lighting switches on. Press the button again to switch the lighting off.
Switch the lighting on if you need more light on your cooking appliance. It is recommended to operate the appliance a few minutes
prior to cooking. Leave the appliance in operation for 5 to 10 minutes after the cooking is finished to remove all the smells from the
kitchen.
cleaning & maintenance
5
Before performing any maintenance operation, disconnect the cooker hood from the mains power supply. Ensure that it is
switched off and pull the plug or remove the connector fuse.
Clean the in- and outside of the cooker hood regularly. Clean the cooker hood with warm soapy water and a soft cloth. If your model
is stainless steel, clean it with a stainless steel care product. Do not use any abrasive cleaning agents such as powder cleaners or
cleaners that contain alcohol. Clean the controls only with a damp cloth.
Attention: failure to carry out the basic cleaning recommendations can cause fire risks.
GREASE FILTERS
A metal grease filter filters the fat particles in the air. Therefore the filter can get clogged, depending on the use. The metal grease filter
does not have to be replaced, but should at least be cleaned once a month. You can clean it either by hand or in the dishwasher on a
low temperature. Make sure the grease filters are competely dry before placing them back.
Do not use any abrasive cleaning agents.
Not cleaning the grease filters on time can cause fire risks.
Cleaning the grease filters in the dishwasher can cause discoloration. This has no effect on the operation.
REMOVING THE GREASE FILTER
Switch off the electricity! Remove the plug from the socket.
Pull the grease filter towards you and tilt it downwards at the
front. Make sure you guide the grease filter with you other hand
to prevent the grease filter from falling down on your cooking
appliance.
REPLACING THE CARBON FILTERS
A carbon filter cleans the air and filters the smell that occurs during cooking. A carbon filter can not
be washed and reused. In all cases it is necessary to replace the carbon filter at least every three
months.
Remove the grease filters.
Attach, depending on the model, one or two carbon filters to the motor.
Replace the grease filters.
CHANGING THE HALOGEN LAMPS
When a light bulb of the cooker hood is broken, you can replace it yourself. Follow these steps:
Unplug the appliance.
Remove the grease filters and push the complete spotlight from the inside down out of the hood.
Carefully remove the glass with a screwdriver.
Pull out the broken halogen lamp and replace it with a halogen lamp matching the wattage stated at the inside of the cooker hood
(maximum 20 Watt, G4).
Refit the glass and push the complete spotlight back in the hood.
Replace the grease filters and plug in the appliance and plug the appliance in.
English 21
AKB9011-AKB9021-instructions.indd 21 27-8-2014 9:29:51
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inventum AKB9021 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inventum AKB9021 in the language / languages: English, Dutch as an attachment in your email.

The manual is 2,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info