686152
8
Zoom out
Zoom in
Previous page
1/23
Next page
(187PO) MODEL ZS8110 OZONE & SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 05/09/2016
187
PO
SAVE THESE INSTRUCTIONS
English
Page 8
SALT & POOL WATER VOLUMES
• Whichkindofsalttouse:
Use only Sodium Chloride Salts
Useonlysodiumchloride(NaCl)saltthatisatleast99.8%pure.Itisalsoacceptabletouse
waterconditioningsaltpellets(thecompressedformsofevaporatedsalt).However,itwilltakea
longer time for them to dissolve.
Do not use iodized or yellow (yellow prussiate of soda) colored salt.
Salt is added to the pool water and the electrolytic cell uses the salt to create chlorine. The purer
the salt the better the performance of the electrolytic cell.
• OptimumSaltLevels
Theidealsaltlevelinthepoolwaterisbetween2500-3500ppm(partspermillion).Theoptimal
level is 3000 ppm.
A too low salt level will reduce the efficiency of the Ozone & Saltwater System and result in
lowchlorineproduction.Ahighsaltlevelmaygenerateasaltytastetothepoolwater(thismay
occuratasaltlevelabove3500-4000ppm).Toohighasaltlevelmaydamagethepower
supply and cause corrosion to the pool metal fixtures and accessories. The Salt Table page of
this manual, shows the correct dosage of salt needed. The salt in the pool is constantly
recycled. The loss of salt is due only to pool water being physically removed from the pool.
Salt is not lost due to evaporation.
• AddingSalt
1
. Switch the filter pump on to start the water circulation.
2
. Keep the Ozone & Saltwater System turned off.
3
. Determinetheamountofsalttobeadded(see“SaltTable”).
4
. Evenly spread the proper amount of salt around the inside perimeter of the pool.
5
. Avoid clogging the filter. Do not add salt through the skimmer.
6
. Brushthepoolbottomtospeedupthedissolvingprocess.Donotallowsalttopileuponthe
bottom of the pool. Run the filter pump 24 consecutive hours to thoroughly dissolve the salt.
7
. After 24 hours and if all the salt is dissolved, turn on the Ozone & Saltwater System, press
button until you hear a “beep”, code “00” flashing and set the saltwater pool system to
desiredoperatingtime(see“OperatingTimeTable”).
• RemovingSalt
Iftoomuchsalthasbeenadded,theunitwillbeepanddisplay“Code92”(see“AlarmCodes”).
Youwillneedtolowerthesaltconcentration.Theonlywaytodoso,istopartiallydrainthepool
andrefillitwithfreshwater.Drainandrefillapproximately20%ofthepool’swateruntilthe“Code
92” disappears.
• PoolVolumeCalculation
Rectangular
Length x Width x Average Depth x 7.5 Length x Width x Average Depth
Circular
Length x Width x Average Depth x 5.9 Length x Width x Average Depth x 0.79
Oval
Length x Width x Average Depth x 6.0 Length x Width x Average Depth x 0.80
Types of Pool
Gallons
(poolsizeinfeet)
Cubic Meters
(poolsizeinmeters)
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intex ZS8110 Krystal Clear at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intex ZS8110 Krystal Clear in the language / languages: English as an attachment in your email.

The manual is 3,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info