686122
13
Zoom out
Zoom in
Previous page
1/22
Next page
254
PO
S AVE THESE INSTRUCTIONS
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 08/31/2018
English
Page 13
LED CODE CHART
E90
No water ow
Turn off and unplug the control unit.
Ensure the outlet cover grid is clean and free
from obstructions.
Clean or replace the cartridge, see
Maintenance and Storage section.
Ensure the in/outlet connections on the spa tub
and lter pump are not blocked.
Keep the spa water properly sanitized to
ensure a clean and unclogged lter cartridge.
If problem persists, contact Intex Service
Center.
E94
Water temperature too low
If the ambient temperature is below 39°F (4°C),
we recommend not to use the spa.
Turn off and unplug the control unit, add some
warm water to raise the spa water temperature
above 5°C (41°F), then press the button to
heat up the water to the desired temperature.
Press the temperature increase button to set
the desired water temperature.
If problem persists, contact Intex Service
center.
E95
Water temperature too high
Turn off and unplug the control unit. When the
water has cooled down, plug the GFCI/RCD
and restart all over again.
Turn the heater off, then press the lter and
bubble buttons to lower the water temperature.
If problem persists, contact Intex Service
Center.
E96
System Error
Turn off and unplug the control unit. Plug the
GFCI/RCD and restart all over again.
If problem persists, contact Intex Service
Center.
E99
Water temperature sensor broken
Contact Intex Service Center.
END
After 72 hours of continuous
heating operation, the pump will
hibernate automatically. The rapid
heating and water ltration
functions are disabled.
Press the button to re-active the lter
pump.
LED Reading CAUSE SOLUTION
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intex Pure Spa 28403 - SSP-H-10-2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intex Pure Spa 28403 - SSP-H-10-2 in the language / languages: English as an attachment in your email.

The manual is 2,01 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info