752269
7
Zoom out
Zoom in
Previous page
1/12
Next page
86A
S AVE THESE INSTRUCTIONS
(86IO) EASY SET POOL ENGLISH 7.5” X 10.3” PANTONE 295U 07/11/2017
English
Page 7
3. Hose connectors
The following applies to pool liners with hose connectors (16" (488 cm) & below pools). If the pool was
purchased
without a filter pump, insert two black plugs (2) into the black filter pump outlets. Do this from
the inside of the pool so that water will not run out when filling it.
If the pool was purchased with a filter pump, read the Krystal Clear™ Filter Pump Manual first and then
proceed to next installation step.
POOL SETUP (continued)
2
3
IMPORTANT
Proper inflation of the top ring.
The ambient temperatures of air and water have an effect on the internal pressure of the top ring.
To maintain a correct internal pressure, it is best to leave some room for expansion as the sun
heats the air inside the ring. During very hot weather, you must check to see whether it is necessary
to release some air. This is to avoid any possible damage to the ring.
In no event shall Intex, their authorized agents or employees be liable for damages (such
as pin holes) to the inflatable top ring caused by negligence, ordinary wear and tear, abuse
and carelessness, or external forces.
You may have purchased this pool with the Intex Krystal Clear™ filter pump. The pump has its
own separate set of installation instructions. First assemble your pool unit and then set up the
filter pump.
Estimated assembly time 10~30 minutes. (Note the assembly time is only approximate and
individual assembly experience may vary.)
1. Liner preparation
• Find a flat, level location that is free and clear of stones, branches or other sharp objects that may
puncture the pool liner or cause injury.
Open the carton containing the liner, etc., very carefully as this carton can be used to store the pool
during the winter months or when not in use.
Take out the ground cloth (3) and spread it over the cleared
area. Then take out the liner (1) and spread it out over the
ground cloth, with the drain valve directed towards the draining
area. Place the drain valve away from the house.
IMPORTANT: Always set up the pool unit with at least 2
persons. Do not drag the liner across the ground as this can
cause liner damage and pool leakage (see drawing 2).
During the setup of the pool liner, point the hose connections
or openings in the direction of the electrical power source. The
outer edge of the pool should be within reach of the pump’s
electrical connection.
Lay out the pool. Spread out the plain blue sides and make the
pool floor as smooth as possible (see drawing 2).
2. Ring inflation
Flip the top ring out and check that it is fully outside of the wall
lining and facing up. Inflate the ring with a manual air pump (see
drawing 3). Keep the top ring centered in the middle of the pool,
while doing this.
IMPORTANT: Prevent bursting by not using a
high-pressure pump, such as an air compressor. Do not
over inflate. Preferably use an Intex manual inflation hand
pump (not included).
1
WATER
LEVEL
Level
FILL LINE
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intex Easy Set 305x61 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intex Easy Set 305x61 in the language / languages: English as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Intex Easy Set 305x61

Intex Easy Set 305x61 User Manual - German - 12 pages

Intex Easy Set 305x61 User Manual - Dutch - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info