595761

Intermec CN50 Windows Embedded Handheld 6.5 Manual

116
Zoom out
Zoom in
Previous page
1/154
Next page
Chapter 9 — Troubleshoot and Maintain the Computer
102 CN50 Mobile Computer for Windows Embedded Handheld 6.5 User Manual
When you release a Scan button or handle
trigger, the Good Read light does not
turn off.
The Good Read light will remain on if you configure
the computer to use continuous/edge triggering. If you
configure the computer for level triggering and the
Good Read light remains on, there may be a problem.
Press one of the Scan buttons or pull the trigger again
without scanning a bar code label. If the light is still on,
contact your local Intermec representative.
The scanner will not read the bar code
label.
• Aim the scanner beam to cross entire bar code label
in one pass. Vary the scanning angle.
• Check the quality of the bar code label, Scan a bar
code label that you know will scan. Compare the
two bar code labels to see if the bar code quality is
too low. You may need to replace the label that you
cannot scan.
• Make sure the bar code symbology is enabled and
configured correctly. Use Intermec Settings to check
the symbologies. Expand Data Collection >
Symbologies beneath devices listed (scanner,
virtual wedge) to check and enable symbologies,
then scan the bar code label again.
• Make sure the computer application is expecting
input from a bar code. You may need to type this
information instead.
The scanner does not read the bar code
labels quickly, or the scanning beam
seems to be faint or obscured.
The scanner window may be dirty. Clean the window
with a solution of ammonia and water. Wipe dry. Do
not allow abrasive material to touch the window.
You scan a valid bar code label to enter
data for your application. The data
decoded by the scan module does not
match the data encoded in the bar code
label.
The computer may have decoded the bar code label in
a symbology other than the label’s actual symbology.
Try scanning the bar code label again. Make sure you
scan the entire label.
Problem Solution
… 116 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intermec CN50 Windows Embedded Handheld 6.5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intermec CN50 Windows Embedded Handheld 6.5 in the language / languages: English as an attachment in your email.

The manual is 4,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info