595724

Intermec CN4 Manual

104
Zoom out
Zoom in
Previous page
1/145
Next page
Chapter 4 — Troubleshooting and Maintaining the CN4
92 CN4 Mobile Computer User’s Manual
The CN4 indicates it is not
authenticated.
Make sure that:
• the User Name and Password parameters on the CN4
must match the user name and password on
authentication server. You may need to reenter the
password on both the CN4, authentication server.
• on your authentication server, the user and group are
allowed and the group policy is allowed to log into the
server. For help, see the documentation that shipped
with your authentication server software.
• the IP address and secret key for access point must
match the IP address and secret key on the
authentication server. You may need to reenter the IP
address and secret key on both your access point and
authentication server.
• the authentication server software is running on the
server PC.
You receive a message saying “The
server certificate has expired or your
system date is incorrect” after you
perform a clean boot on the CN4.
Date and time are not saved when you perform a clean
boot. Reenter the date and time, and then save your
changes.
Problems Reading Bar Codes
Problem Solution
You cannot see a red beam of light from
the imager when you press the Scan
button and aim the imager at a bar
code label.
• You may be too far away from the bar code label. Try
moving closer to the bar code label and scan it again.
• You may be reading the bar code label “straight on.”
Change the reading angle and try again.
• The imager hardware trigger might be disabled in
Intermec Settings. To check the setting go to Start >
Settings > System Tab > Data Collection > Scanner
Settings. Hardware trigger should be checked.
The input device attached to the
computer does not work well or read
bar code labels very quickly.
Set the Scanner Model command to the specific attached
input device. Check enabled bar code symbologies and
enable only the symbologies being used.
Problems While Configuring 802.1x Security (continued)
Problem Solution
… 104 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Intermec CN4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Intermec CN4 in the language / languages: English as an attachment in your email.

The manual is 7,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info