799585

Instant Pot Smart Bluetooth Manual

19
Zoom out
Zoom in
Previous page
1/24
Next page
19
3. Prepare 1 cup of cold boiled water, (normally at a water-to-dry-rice rao of 1:2), starter yeast
powder, and a glass or ceramic container with lid. Make sure that all tools are clean and free
from bacteria, oil and salt.
4. Aer the steamed rice cool down to below 35°C/95°F, mix the cold water and yeast powder
with the rice thoroughly in the container. Make sure that each rice grain is separated, rather
than stuck together. Gently press the rice mixture together and leave a hole in the middle of
the mixture.
5. Add water to the 3rd mark in the inner pot. Lower the container
into the inner pot with the steam rack. Water should submerge
about 1cm/0.5in of the boom of the container for even heat
conducon. Make sure to close the lid of the container to avoid
excess evaporaon from the rice.
6. Press the “Yogurt” funcon key and then press the “Adjust” key
twice to “Less” mode for Jiu Niang funcon. The default
fermentaon me is 24 hours. You may need to change this
following the instrucon of the yeast.
7. Jiu Niang will be ready when the program nishes. A well-made
fermented glunous rice has transparent liquid and some small
gas bubbles with an aromac smell of liquor and is very sweet. If
there are some white fungi on surface, this is normal. If it has
black fungi, the rice was contaminated during the process and it
should not be consumed. Avoid running the fermentaon for too
long, which causes the rice to turn sour.
8. When the program completes, Instant Pot beeps, displays “yogt” and goes to standby state.

In order to get a feel for your Instant Pot before jumping in with your favorite recipe, it’s a great
idea to take it for a test run. This will help you to become familiar with your Instant Pot, make sure
that your unit is working perfectly and also clean the unit of possible residues in the process. This
test run can be accomplished in about 15 minutes. It’s oponal but recommended.
1. Make sure the steam release handle and oat valve are
unobstructed and clean and that the sealing ring is properly
seated.
2. Insert the inner pot in the cooker base and add water to the “3”
mark on the inner pot.
3. Close the lid. Make sure that the steam release handle is poinng
to "Sealing" mark on the lid.
4. Press the "Steam" key, and press the “-“ buon to change the
me to 2 minutes.
5. In 10 seconds, your Instant Pot will go into the preheang cycle
(display showing “On”). Within a few minutes steam will start
coming out for a minute or two unl the Float Valve pops up and
seals the cooker. Within another minute or two the working
pressure will be reached and the countdown mer will begin.
Once the countdown is nished, your Instant Pot will beep and automacally go into the
“Keep Warm” mode.
That’s it. The test is complete. Press the “Keep-Warm/Cancel” buon and/or unplug the unit.
Once the pot cools down, you can open it and are ready to try your favorite recipe.
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Instant Pot Smart Bluetooth at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Instant Pot Smart Bluetooth in the language / languages: English as an attachment in your email.

The manual is 4.04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info