738445
29
Zoom out
Zoom in
Previous page
1/36
Next page
Step 27
Step27: Initially adjust the four cable bolts to 1” between the top of the bolt and the
bracket it is attached too and Wrench Tighten the Jam Nuts.
Start with one Cable and adjust the slack out. Then do the same with
the other three Cables. Assure the cables routing is clear and in the
grooves of all pulleys.
There has to be a minimum of one Bolt thread showing below
the Nuts after adjustment.
At this point it is necessary to seat the cables. Start by
verifying that cables are centered in the grooves of all
pulleys and clear of all guides and potential obstructions.
Shake Down, select a weight that you can comfortably
handle. Perform a standard exercise and hold the first
repetition. Now, lightly bounce the weights up and down
several times. This will seat the cables into the pulleys
and prepare the Smith Cage System for final adjustments.
Readjust the cables with the Cable Bolts to remove any Cable Clevis
new slack. If after readjusting the cables there is still
excess slack, you can adjust more slack out by moving
the clevis on the end of the Lower Cables to the lower
hole in the Cable Anchor.
Lower Hole
If after adjusting cable length(s) as noted above and the cable
appears to be too short, remove the Top Weight Pulley, screw out
the “U” bracket one to two full turns, then retighten the Jam Nut,
and re-attach the pulley. Make sure the Locknut on the Pulley bolt
is facing toward the back of the cage.
Page 26
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inspire SCS-202 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inspire SCS-202 in the language / languages: English as an attachment in your email.

The manual is 4,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info