738441
27
Zoom out
Zoom in
Previous page
1/38
Next page
Step 31: Tilt Guide Rods back to install Rubber Donuts, 20 Weight Plates (Weight Stack), Top Weight/Selector
Stem (In That Order). See Note below.
Make sure the U Bracket at the top of the Selector Stem is fully inserted in the stem, turned sideways as shown
and tighten the jam nut under the U Bracket against the Selector Stem.
Attach pulley (with cable from upper pulleys wrapped around it) to the U bracket on top of the Selector Stem.
Make sure cable is not twisted. Tighten Now!!
Note: If Guide Rods don’t tilt back far enough to slide on weights, loosen bolt under Lower Guide Rod Mount
slightly. Tighten again after weights are on.
INSTALL WEIGHT STICKERS NOW
Front of weight plate has recessed area for weight plate number.
Slide Weight Pin into one of the weights after installed.
Page 24
Step 31
1 M10 x 45 Hex Bolt
2 M10 Flat Washers
1 M10 Lock Nut
Weight Stack
Rubber Donuts
Bottom of
Weight Plate
has 3 feet.
Front of Weight
Plate has recessed
area.
Shroud Plate
After Weight Stack installed, Guide Rods
should be in front of the top Flange
Selector Stem/ Top Weight
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inspire M3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inspire M3 in the language / languages: English as an attachment in your email.

The manual is 9,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info