738441
15
Zoom out
Zoom in
Previous page
1/38
Next page
Large Ball
End
L/E Cam
Bolt Head must fit snug against Anti-Rotation Tab
Pre-assembled Cam Plate
Pulleys
1 M12 x 95 Hex Bolt
1 M12 Flat Washers
1 M12 Thin Lock Nut
Note: washer on nut side only.
4 M6 Flat Head Cap Screws
1 Cam Plate
Small Cable End
Leg Extension Cable L/E Assembly
Seat Base Frame
Step 12: Begin by removing the 4 Flat Head Cap Screws and the Cam Plate from the Leg
Extension Cam (L/E Cam). Next, using these same 4 Flat Head Cap Screws and the
Cam Plate, attach the Leg Extension cable to the L/E Cam, as shown in the above
diagram.
Step 13: Attach L/E Cam and L/E Assembly to Seat Base. NOTE: Washer on nut side only.
NOTE: Be sure to thread Leg Extension Cable through pre-assembled pulleys as L/E Cam and
L/E Assembly are attached.
NOTE: Tighten Now, Do Not Over Tighten. L/E Assembly should swivel freely.
Page 14
STEP 1
2
S
TEP 13
This
large
Ball End to be attached
to
L/E Cam as shown above.
NOTE
:
If small c
able end won’t fit
between pre-assembled Pulleys,
loosen or remove Lower Pulley,
insert cable end between the Upper
Pulley and the metal plate, then re-
attach the Lower Pulley.
PAGE 12
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inspire M3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inspire M3 in the language / languages: English as an attachment in your email.

The manual is 9,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info