738440
22
Zoom out
Zoom in
Previous page
1/30
Next page
Step 33
3-Shroud Plate Connector Pins
Step 34
3- T Pins
Step 33: Slide a Shroud C Bracket into the pocket at one end of Shroud. (Pocket
seam should face inside). Work shroud around bracket until the opening in the
shroud lines up with the hole on the back of the bracket. Repeat this on the other
end of shroud.
Now position this shroud assembly around the upper and lower Shroud Mount
Plates by working around guide rods and stack. Align holes in the top and bottom
brackets with the holes in the plates and insert Shroud Plate Connector Pins in each
(3 at top and 3 at bottom).
Next, stretch the
shroud tight using the
2 knobs at the top,
turn counter clockwise
working between the
2 knobs to adjust
each side up a little at
a time.
Tightening Knobs
Step 34: The press
arm starting position
may be adjusted by
screwing press arm
stop in or out. Lock
with jam nut when
finished.
Adjust cable slack at
the upper single
floating pulley by
loosening bolt and
moving pulley up or
down with the
selector plate. Lock
tight with bolt
when finished.
Adjust the Stop at the Single Floating Pulley for
the leg extension to take slack out of the cable.
Set the cam so the cable opening is in line with the
2 small pulleys before adjusting. Tighten the Jam
Nut when finished.
PAGE 18
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Inspire M2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Inspire M2 in the language / languages: English as an attachment in your email.

The manual is 7,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info