590371
17
Zoom out
Zoom in
Previous page
1/20
Next page
15
Insignia NS-R2001 AM/FM Stereo Receiver
www.insigniaproducts.com
Maintaining
To clean this receiver, wipe with a soft, dry cloth. If
the surfaces are extremely dirty, use a soft cloth
dipped in a soap and water solution or a weak
detergent solution.
Never use alcohol, paint thinner, or benzine to
clean this receiver.
Before using a chemically treated cloth, read the
instructions that came with the cloth carefully.
Troubleshooting
If a problem occurs, run through the table below
before contacting Insignia.
If the problem persists, attempt to solve it by
switching the receiver off and on again. If this fails
to resolve the problem, contact Insignia. Under no
circumstances should you attempt to repair the
receiver yourself as this could void the warranty.
Category Problem Possible Solution
No power.
•The AC power cord is
disconnected.
Poor connection at AC wall
outlet or the outlet is
inactive.
Connect the cord securely.
Check the outlet using a lamp or
another appliance.
No sound.
The speaker cords are loose
or disconnected.
The volume is adjusted too
low.
•The MUTE button on the
remote control is pressed to
ON.
Speakers are not switched
on.
Incorrect selection of the
input source.
Incorrect connections
between the components.
The correct speaker is not
selected.
Check the speaker connections.
Adjust the volume.
•Press the MUTE button to cancel the
muting effect.
Turn on one or both speakers.
Select the desired input source
correctly.
Make connections correctly.
•Press SPEAKER A or B to select the
correct speakers.
Stations cannot
be received.
No antenna is connected.
The desired station
frequency is not tuned in.
The antenna is in wrong
position.
Connect an antenna.
Tune in the desired station
frequency.
Move the antenna and retry tuning.
Preset stations
cannot be
received.
•An incorrect station
frequency has been
memorized.
•The memorized stations are
cleared.
No antenna is connected.
The antenna is not
positioned for the best
reception.
The receiver is not in
PRESET mode.
Memorize the correct station
frequency.
Memorize the stations again.
Connect an antenna.
Change the position of the
antenna.
•Press TUNE/PRESET until the
PRESET indicator lights.
Poor FM
reception.
No antenna is connected.
The antenna is not
positioned for the best
reception.
The antenna connection
may not to secure.
You may not be fully tuned
to the correct frequency.
Connect an antenna.
Change the position of the antenna.
Make sure that the antenna is
properly secured.
Make sure that you are tuned to the
correct frequency.
Try using an outdoor antenna.
Continuous
hissing noise
during FM
reception,
especially
when a stereo
broadcast is
received.
•Weak signals.
The antenna connection
may not to secure.
You may not be fully tuned
to the correct frequency.
The receiver may be too
close to a TV or another
appliance.
Change the position of the antenna.
Install an outdoor FM antenna.
Make sure that the antenna is
properly secured.
Make sure that you are tuned to the
correct frequency.
Move the devices or turn them off.
Try using an outdoor antenna.
Continuous or
intermittent
hissing noise
during AM
reception,
especially at
night.
Noise is caused by motors,
fluorescent lamps, or
lightning.
Keep the receiver away from noise
sources.
Install an outdoor AM antenna.
No recording.
Incorrect selection between
the components.
Incorrect operation of each
component for playback and
recording.
Make connections correctly.
Operate each component correctly.
There is noise
or a humming
sound.
The receiver may be too
close to a TV or another
appliance.
Connect the turntable’s ground cord
to the PHONO GND terminal.
Move the devices or turn them off.
The sound lacks
bass.
The speaker polarity (+/–)
might be reversed.
Check all speakers for correct
polarity.
The volume of
SPEAKER A is
different from
that of
SPEAKER B.
•The volume and sound
quality may differ
depending on the speaker’s
size, etc.
Connect the same type of speakers
to the SPEAKERS A and B terminals if
you want to use SPEAKERS A and B at
the same time with the same
volume.
I can hear the
audio, but I
can’t see the
video on my TV.
The correct video input on
the TV is not selected.
Select the input source that matches
the device connected to the TV.
Remote control
unit does not
operate.
Batteries are not installed or
are dead.
The remote sensor is
obstructed.
Replace the batteries.
Remove the obstacle.
Category Problem Possible Solution
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Insignia NS-R2001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Insignia NS-R2001 in the language / languages: English as an attachment in your email.

The manual is 5,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info