685030
3
Zoom out
Zoom in
Previous page
1/4
Next page
INSTALLATION
Recommendations
Important: Disconnect the hob from the mains before carrying out any
installation work or servicing.
All electrical connections must be made before connecting the appliance to
the power supply.
Installation must be carried out by a qualied technician in accordance with the
manufacturer’s instructions and in compliance with local regulations.
Unpack the hob and make sure that the appliance has not been damaged during
transport. If you are not sure contact the dealer or the nearest service centre.
Preparing the housing unit
Cut the worktop to t before installing the appliance. Carefully remove any
shavings or sawdust that could prevent the appliance from running properly.
Attention: to install the hob on other surfaces than wood (marble, plastic, ceramic,
marble, stone, etc.) remember to ask After Sales Service for the xing plates (g.
2) Code 4819 404 78697.
The hob must be tted in a worktop with a minimum thickness of 20 mm and
a maximum of 50 mm.
Insert a separator panel at a minimum distance of 90 mm from the bottom of
the hob, so that it cannot be accessed by the user.
If there is an oven under the hob, make sure that it is manufactured by us and
equipped with a cooling system.
There must be nothing between the hob and the oven (e.g. cables, insulating
material, etc.).
An adjacent column unit must be installed at least 100 mm from the edge of
the hob.
Cut an opening in the worktop of the given dimensions.
We recommend you seal the internal edges of the worktop with wood glue or
silicone.
If not already in place, apply the supplied seal to the hob, after cleaning the
adhesive surface thoroughly.
Glass-ceramic hob
Important: remove any protective lm before installing the hob.
Make sure that that the opening in the worktop for the hob is cut according to the
dimensions given in the drawing, paying attention to the tolerance range.
The hob should not be forced into the worktop. Forcing the glass-ceramic top may
cause it to crack (even at a later date)!
If the worktop is made of wood, use the spring clips and screws provided.
1. Secure the spring clips (A) (g. 1) with the screws provided (B) (g. 1) as shown,
paying attention to the specied distances.
2. Fit the hob into the worktop.
If the worktop is made of marble, plastic, ceramic, stone, etc., the hob must be
secured with special brackets (C) (g. 2).
1. Fit the hob into the worktop (g. 1).
2. Place the 4 brackets (C) in position in accordance with the thickness of the
worktop as shown in g. 2.
3. Fasten the 4 screws (D) in the positions (E) (g. 2).
Electrical connection
Regulations require that the appliance be earthed.
Connection to the mains must be carried out by a qualied technician in
accordance with the manufacturer’s instructions and in compliance with local
regulations.
The installer is responsible for connecting appliances correctly to the mains and
for observing the safety regulations.
The oven power cable must be long enough to connect the built-in appliance
to the mains.
Observance of safety directives requires that a multipole switch with a minimum
contact gap of 3 mm be used for the installation.
Do not use multiple plug adapters or extension leads.
After the oven has been installed, the electrical components must be
inaccessible.
Connecting the oven to the power supply
Note: the yellow/green earth wire must be connected to the screw with the symbol
.
Strip approx. 70 mm of the cable sheath from the power supply cable (G).
Strip approx. 10 mm of sheath from the conductors. Insert the cable (G) through
the opening in the lid (F).
Insert the cable into the cable clamp and connect the conductors to the terminal
block as indicated in the diagram printed on the lid.
Secure the power cable (G) by means of the cable clamp.
Ret the protection lid (F).
After the electrical connection, t the hob from the top and hook it to the xing
springs, according to the illustration.
Declaration of conformity
This cooktop is suitable for contact with foodstus and complies with EEC (CE)
Regulation n. 1935/2004.
This hob (Class Y) has been designed to be used only for cooking. Any other
use (such as heating a room) is improper and dangerous.
This hob has been designed, constructed and marketed in compliance with:
- safety objectives of the “Low Voltage” Directive 2006/95/EC (which replaces
73/23/EEC and subsequent amendments);
- the protection requirements of Directive “EMC” 2004/108/EC;
- requirements of EEC Directive 93/68.
The Manufacturer reserves the right to change product specications without
prior notice.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Indesit RI 860C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Indesit RI 860C in the language / languages: English as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Indesit RI 860C

Indesit RI 860C User Manual - English - 5 pages

Indesit RI 860C User Manual - German - 5 pages

Indesit RI 860C User Manual - German - 4 pages

Indesit RI 860C User Manual - Dutch - 5 pages

Indesit RI 860C User Manual - Dutch - 4 pages

Indesit RI 860C User Manual - French - 5 pages

Indesit RI 860C User Manual - French - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info