Manual Indesit kp 9507 xe o (page 8 of 40) (English, German, Dutch, French, Italian)

326776

Zoom out

Zoom in

1/40

INSTRUCTIONS FOR THE INSTALLER

Kitchen ventilation

The air flow into the room where the appliance is installed

must equal the quantity of air that is required for regular

combustion of the gas and for ventilating the same room.

Air must be taken in naturally through permanent apertures

made in the outside walls of the room or through single or

branching collective ventilation ducts in compliance with

the standards in force.

The air must be taken directly from the outside, from an

area far from sources of pollution.

The ventilation aperture must have the following

characteristics (fig.7A):

· total free cross section of passage of at least 6 cm² for

every kW of rated heating capacity of the appliance, with

a minimum of 100 cm² (the heating capacity is indicated

on the rating plate);

· it must be made in such a way that the aperture, both on

the inside and outside of the wall, cannot be obstructed;

· it must be protected, e.g. with grills, wire mesh, etc. in

such a way that the above-mentioned free section is not

reduced;

· it must be situated as near to floor level as possible.

The air inflow may also be obtained from an adjoining room,

provided the latter is not a bedroom or a room where there

is a risk of fire, such as garages, mews, fuel stores, etc.

and is ventilated in compliance with the standards in force.

Air from the adjoining room to the one to be ventilated may

be made to freely pass through permanent apertures with

a cross section at least equal to that indicated above. These

apertures may also be obtained by increasing the gap

between the door and the floor (fig.7B).

If an electric fan is used for extracting the combustion

products, the ventilation aperture must be increased in

relation to its maximum performance. The electric fan should

have a sufficient capacity to guarantee an hourly exchange

of air equal to 3-5 times the volume of the kitchen.

Detail A Adjacent Room to be

room ventilated

Examples of ventilation holes Enlarging the ventilation slot

for comburant air between window and floor

fig. 7A fig. 7B

The following instructions are provided for qualified installers

so that they may accomplish installation, adjustment and

technical maintenance operations correctly and in

compliance with current regulations and standards.

Important: the appliance should be disconnected from

the mains electricity supply before any adjustment,

maintenance, etc. is carried out. Maximum caution should

be used whenever it is necessary to keep the appliance

connected to the electricity supply.

The cookers have the following technical specifications:

Category: II 2H3+ Class: 1

The dimensions of the appliance are given in figure on

page 2. For trouble-free operation of appliances installed

between housing units, the minimum distances shown in

fig.5 should be observed. Adjacent surfaces and the wall

at the rear should also be able to withstand a temperature

of 65 °C. In the lower part of the cooker there are 4 height

adjustable screw-in feet with which it is possible to level

the cooker if necessary.

Positioning

This appliance may only be installed and operated in

permanently ventilated rooms in compliance with provisions

laid down by current regulations and standards. The

following requirements must be observed:

• The appliance must discharge combustion products into

a special hood, which must be connected to a chimney,

flue pipe or directly to the outside (fig.6).

• If it is impossible to fit a hood, the use of an electric fan

is permitted, either installed on a window or on an external

wall, which must be switched on at the same time as the

appliance.

fig.5

fig.6

In a chimney stack or branched flue Directly to the outside

(exclusively for cooking appliances)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Indesit kp 9507 xe o in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,81 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Indesit kp 9507 xe o Manual

Product: