684560
2
Zoom out
Zoom in
Previous page
1/2
Next page
CLEANING AND MAINTENANCE
Make sure that the oven has cooled down before carrying out any maintenance or cleaning. Do not use steam cleaners. Do not
use wire wool, abrasive scourers or abrasive/corrosive cleaning agents, as these could damage the surfaces of the appliance. Wear
protective gloves. The oven must be disconnected from the mains before carrying out any kind of maintenance work.
EXTERIOR SURFACES
Clean surfaces with a damp microbre cloth. If they are very dirty,
add a few drops of pH-neutral detergent. Finish o with a dry cloth.
Do not use corrosive or abrasive detergents. If any of these products
inadvertently comes into contact with the surfaces of the appliance,
clean immediately with a damp microbre cloth.
INTERIOR SURFACES
After every use, leave the oven to cool and then clean it, preferably
while it is still warm, to remove any deposits or stains caused by
food residues. To dry any condensation that has formed as a result
of cooking foods with a high water content, leave the oven to cool
completely and then wipe it with a cloth or sponge. Clean the glass in
the door with a suitable liquid detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution after use, handling
them with oven gloves if they are still hot. Food residues can be
removed using a washing-up brush or a sponge.
LOWER THE TOP HEATING ELEMENT (Only in some models)
The top heating element of the grill can be lowered to clean the upper
panel of the oven: Extract the heating element from its seating, then
lower it. To return the heating element to its position, lift it up, pull it
slightly towards you and make sure that the tab support is in its proper
seating.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the catches until they are
in the unlock position (1). Close the door as much as you can (2). Take
a rm hold of the door with both hands - do not hold it by the handle.
Simply remove the door (3) by continuing to close it while pulling it
upwards (a) at the same time until it is released from its seating (b).
1
2
~60°
3
a
b
~15°
Put the door to one side, resting it on a soft surface. Ret the door by
moving it towards the oven, aligning the hooks of the hinges with their
seating and securing the upper part onto its seating. Lower the door
and then open it fully. Lower the catches into their original position:
make sure that you lower them down completely. Try closing the door
and check to make sure that it lines up with the control panel. If it does
not, repeat the steps above.
CLICK & CLEAN - CLEANING THE GLASS
After removing the door and resting it on a soft surface with the
handle downwards, simultaneously press the two retaining clips (1) and
remove the upper edge of the door by pulling it towards you (2).
1
2
Lift and rmly hold the inner glass with both hands, remove it and
place it on a soft surface before cleaning it (3).
3
To correctly reposition the inner glass, make sure that the “R” is visible
in the left-hand corner and the clear surface (not printed) is facing up.
First insert the long side of the glass indicated by “R” into the support
seats, then lower it into position (4). Ret the upper edge (5): a click
will indicate correct positioning. Make sure the seal is secure before
retting the door.
4
5
REPLACING THE LAMP
Disconnect the oven from the power supply, unscrew the cover from
the light, replace the bulb and screw the cover back on the light.
Reconnect the oven to the power supply. Do not use the oven until the
light cover has been retted.
Please note: Only use 25W/230 ~ V, G9 type, T300°C halogen bulbs. The
bulb used in the product is specifically designed for domestic appliances
and is not suitable for general room lighting within the home. Light bulbs
are available from our After-sales Service.
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The oven is not working. Power cut.
Disconnection from the mains.
Check for the presence of mains electrical power and whether the
oven is connected to the electricity supply.
Turn o the oven and restart it to see if the fault persists.
400011097438
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
Visiting our website docs . indesit . eu
Using QR Code
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication
plate.
XXXXXXXXXXXXXX
Model: xxxXXXXxx
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Indesit IFW 5530 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Indesit IFW 5530 in the language / languages: English as an attachment in your email.

The manual is 1,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Indesit IFW 5530

Indesit IFW 5530 Quick start guide - German - 2 pages

Indesit IFW 5530 Quick start guide - Dutch - 2 pages

Indesit IFW 5530 Quick start guide - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info