Manual Indesit idl 75 eu 2 (page 22 of 76) (English, German, Dutch, French, Italian, Portuguese, Spanish)

127055

Zoom out

Zoom in

1/76

Cleaning and special maintenance

Is there a problem?

Your dishwasher may not work or not function properly.

Before calling for assistance, let’s have a look at what can be

done: you may have forgotten to press a button or for some

reason or another you haven’t carried out a procedure

necessary for the appliance to operate correctly.

The dishwasher won’t start

Have you checked:

whether the tap has been turned on and is well connected

to the hose or whether there is no water throughout your

home or whether the pressure of the water supply is

sufficient, whether the hose is bent or the filter on the water

supply hose is blocked, whether the door is open?

The dishes are not clean

Have you checked:

whether the right amount of detergent is in the dispenser,

the wash cycle selected is suitable for the dishes loaded, or

whether the filter and the microfilter are clean and whether

the sprayer arms can turn freely?

The dishwasher won’t drain

Have you checked:

Is the drain hose bent?

Limescale deposits or a white film form on the dishes.

Have you checked:

whether the lid on the salt container is closed properly or

whether the amount of rinse aid has been adjusted correctly?

Error messages.

The dishwasher is equipped with a safety system which is able to

detect any operating anomalies. These anomalies are reported by

one or two wash cycle indicator lights “G” flashing rapidly. Take a

note of which lights are flashing, turn the appliance off and call for

technical assistance.

Tap off alarm

If you have forgotten to turn the water tap on, your appliance will

remind you of this by sounding a few short beeps for a few minutes.

Turn the tap on and your appliance will start up again after a few

minutes. Were you to be absent when these beeps are sounded,

the appliance will be blocked automatically and indicator lights 2

and 3 (wash and rinses) will flash rapidly. Turn the appliance off at

the ON-OFF button, turn on the water tap and wait approximately

20 seconds before turning the appliance back on, re-select a wash

cycle as indicated in the “Selecting the wash cycle” paragraph and

the appliance will start up again.

Clogged filter alarm

If the appliance is blocked and indicator lights 1 (pre-wash) and 3

(rinses) flash rapidly , this means the filter is clogged by large particles

of food residue. Turn the appliance off, clean the filter thoroughly,

reposition it in its seat and then turn the appliance on again. The

selected wash cycle will start up again.

Water load solenoid valve malfunction alarm.

If indicator light 2 (wash) flashes rapidly, TURN the dishwasher OFF

AND BACK ON AGAIN after one minute. If the alarm persists, first

turn off the water tap to avoid any flooding and then cut off the

electricity supply and call for technical assistance.

If any other indicator lights apart from the above-mentioned ones

flash rapidly, turn the appliance off and call for technical assistance.

If, despite all these checks, your dishwasher still won’t

work and the trouble you are having persists, call your

nearest authorised service centre, mentioning the

following information:

- the type of malfunction

- the model type no. (Mod. ....) and the serial number (S/N….)

indicated on the rating plate located on the inner door, to one side.

Never call upon the services of unauthorised

technicians and always refuse spare parts that are

not originals.

The filter assembly

If you want consistent good results from your dishwasher,

you need to clean the filter assembly.

The food particles are removed from the wash water, allowing

it to be recirculated during the cycle, filtered perfectly. For

this reason, it is a good idea to remove the larger food

particles trapped inside the cup “C” and the semi-circular

filter A after each wash; pull the cup handle upwards to

remove them. Just rinse them under running water.

The entire filter assembly should be cleaned thoroughly once

a month: cup C + semi-circular filter A + cylindrical filter B.

Rotate filter “B” anticlockwise to remove it.

For cleaning, use a non metallic brush.

Reassemble the filter parts (as shown in the figure) and

reinsert the whole assembly into the dishwasher. Position it

into its housing and press downwards.

The dishwasher is not to be used without filters. Improper

replacement of the filters may reduce the efficiency of the

wash and even damage your dishwasher.

Cleaning the sprayer arms.

Food residue may become encrusted onto the sprayer arms

and block the holes where water comes out. Check the

sprayer arms regularly and clean them once in a while

(letters F and I “How is it made?”).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Indesit idl 75 eu 2 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3,52 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Indesit idl 75 eu 2 Manual

Product: