Manual Indesit IDL 730 (page 8 of 16) (English)

34637

Zoom out

Zoom in

1/16

Turning on the Appliance

How to start a wash cycle…

After performing all the operations described in the previous

paragraphs, turn the water tap on completely and press ON-

OFF button "A": you will hear a short beep and indicator

light "B" lights up. At this point, the appliance is on and

ready to be programmed

Starting and selecting the cycle.

Turn the cycle selector knob "D" clockwise until the reference

notch on the knob corresponds with the number or symbol

for the cycle you wish to set (consult the wash cycle table on

page 7, especially when first using the appliance).

If the appliance door is shut, press the Start button "R" and

you will hear a beep; the cycle will start up within a few

seconds.

Cycle phase indicator lights

The dishwasher is provided with 4 indicator lights "G" which

come on in sequence as the appliance is performing that

specific phase of the wash cycle.

These phases are:

pre-wash, wash, rinses, drying

Note: the rinses light is also used to indicate the 3-in-1 button

activation.

Cancelling or modifying a wash cycle in progress…..

Premise: You can cancel the wash cycle in progress, if it has

only just started.

To modify a wash cycle, keep the RESET button "R" pressed

for about 5 seconds: a prolonged beep will sound, followed

by three short beeps. Indicator light "G" will turn off and at

this point, all the settings will have been cancelled.

To select a new wash cycle, repeat the operations illustrated

in the paragraph entitled "starting and selecting the cycle".

If you have left out a dish…

You can interrupt a wash cycle by pressing the ON-OFF

button, then place the dishes you had left out into the

appliance, which will start up from where it was interrupted

when you turn it back on.

There's been a power failure? Have you opened the

dishwasher door?

The wash cycle stops and then restarts when the electricity

comes back on or when the door is shut.

At the end of the wash cycle….

The end of the wash cycle is indicated by two short beeps

and the flashing of the drying phase indicator light.

Warning:

Turn the appliance off by pressing button “A”, unplug

the appliance from the electricity socket to cut off the

power supply; the power supply cable should

consequently be easily accessible.

• Turn off the water tap.

• Wait a few minutes before unloading the dishes: if you

wait a little while, they dry better thanks to the steam.

• Empty the lower rack first.

Warning: when you open the dishwasher door after the wash

cycle has just ended or is under way, take care not to scald

yourself with the hot steam.

3-in-1 button.

Press before selecting a cycle.

If you press this button when you are intending to use 3-in-1

tablets (detergent + salt + rinse aid), the washing and drying

performance of your dishwasher will be greatly improved.

When this function is selected, the overall cycle time will

increase by approximately 15 minutes.

When the button has been activated correctly, you will hear

a prolonged beep and the indicator light "G" will light up.

When the button has been deactivated, you will hear a short

beep and the 3-in-1 indicator light will switch off.

• When the cycle begins, the 3-in-1 indicator light will switch

off.

• The 3-in-1 option is cancelled automatically at the end of

each cycle.

This button cannot be used in conjunction with the quick

wash and soak cycles.

You want to wash on one rack only?

Remember to use half the amount of

detergent.

Your dishwasher also allows you to wash half a load on the

upper rack only, to save water and electricity. Before setting

any wash cycle, press button "I", the indicator light "L" lights

up.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Indesit IDL 730 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Indesit IDL 730

Indesit IDL 730 User Manual - English - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Indesit IDL 730 Manual

Product: