126444
17
Zoom out
Zoom in
Previous page
1/24
Next page
17
EN
A
B
D
C
Start-up and use
* Only available in selected models.
Starting the dishwasher
1. Turn the water tap on.
2. Press the ON/OFF button: the indicator light will
illuminate.
3. Open the door and pour in a suitable amount of
detergent (
see below
).
4. Load the racks (
see Loading the racks
) and shut
the door.
5. Select the desired wash cycle depending on the
dishes and how dirty they are (
see table of wash
cycles
), by turning the knob clockwise.
6. Select the wash options* (
see below
).
7. Start the cycle by pressing the START/RESET
button: the machine will emit a confirmation beep.
The WASH CYCLE PHASE indicator lights display
the status of the cycle:
Pre-wash, Wash, Rinse, or Drying.
8. At the end of the cycle three short beeps will sound
and the DRYING indicator light will flash.
9. Switch off the appliance by pressing the ON/OFF
button, shut off the water tap and unplug the
appliance from the electricity socket.
10.Open the door and wait for a few minutes before
removing the crockery, in order to avoid burns.
Unload the racks, beginning with the lower level.
Modifying the wash cycle in progress
If a mistake was made during the wash cycle selection
process it is possible to change the cycle, provided
that it has only just begun: press and hold the START/
RESET button for 4 seconds. After one long beep and
three short beeps, the WASH CYCLE PHASE indicator
light will switch off: select the new cycle and switch
the machine back on by pressing the START/RESET
button.
Adding extra crockery
Press the ON/OFF button and open the door, taking
care to avoid the escaping steam, and place the
crockery inside the dishwasher. Press the ON/OFF
button again: the cycle starts from the point at which it
was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if there
is a power cut, the cycle stops. It starts again from the
point at which it was interrupted once the door has
been shut or the electricity supply is restored.
Loading the detergent
A successful wash also depends on the correct
amount of detergent being used, as recommended by
the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
To obtain the best results from each washing and
drying cycle, powder detergent, rinse aid liquid and
salt should be used.
compartment A: Washing detergent
compartment B: Pre-wash detergent
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the
Wash
cycle table
:
• for powder detergent
use compartments A and
B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the cycle
requires 1 tablet, place it in compartment A and
close the cover; when it requires 2, place the
second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Indesit idl 507 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Indesit idl 507 in the language / languages: English, French as an attachment in your email.

The manual is 1,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info