577360
20
Zoom out
Zoom in
Previous page
1/76
Next page
GB
20
5. Fix the power supply cable in place by fastening the
cable clamp screw.
6. Close the terminal board cover by tightening the
screws V.
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load
indicated on the data plate located on the appliance.
The appliance must be directly connected to the mains
using an omnipolar circuit-breaker with a minimum
contact opening of 3 mm installed between the
appliance and the mains. The circuit-breaker must be
suitable for the charge indicated and must comply with
current electrical regulations (the earthing wire must
not be interrupted by the circuit-breaker). The supply
cable must be positioned so that it does not come into
contact with temperatures higher than 50°C at any
point.
Before connecting the appliance to the power supply,
make sure that:
The appliance is earthed and the plug is compliant with
the law.
The socket can withstand the maximum power of the
appliance, which is indicated by the data plate.
The voltage is in the range between the values
indicated on the data plate.
The socket is compatible with the plug of the
appliance. If the socket is incompatible with the
plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power
supply cable and the electrical socket must be easily
accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced
by authorised technicians only.
! The manufacturer declines any liability should
these safety measures not be observed.
60 l
42,4 cm x 34,0 cm x 41,0 cm
Safety Chain
! In order to prevent accidental tip-
ping of the appliance, for example by
a child climbing onto the oven door,
the supplied safety chain MUST be
installed!
The cooker is tted with a safety chain
to be xed by means of a screw (not
supplied with the cooker) to the wall behind the appliance, at
the same height as the chain is attached to the appliance.
Choose the screw and the screw anchor according to the type
of material of the wall behind the appliance. If the head of the
screw has a diameter smaller than 9mm, a washer should be
used. Concrete wall requires the screw of at least 8mm of dia-
meter, and 60mm of length.
Ensure that the chain is xed to the rear wall of the cooker
and to the wall, as shown in gure, so that after installation
it is tensioned and parallel to the ground level.
Regulation (EU) No 65/2014
supplementing Directive 2010/30/EU.
Regulation (EU) No 66/2014
implementing Directive 2009/125/EC.
Standard EN 60350-1
Standard EN 50564.
ENERGY LABEL
and ECODESIGN
Standard EN 60350-2.
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Indesit I5V7H6A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Indesit I5V7H6A in the language / languages: English, German, French, Polish as an attachment in your email.

The manual is 10,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info