124773
17
Zoom out
Zoom in
Previous page
1/36
Next page
17
EN
Loading the detergent
A successful wash also depends on the correct
amount of detergent being used, as recommended
by the manufacturer. Exceeding the recommended
amount does not result in a more effective wash and
pollutes the environment.
To obtain the best results from each washing
and drying cycle, powder detergent, rinse aid liquid
and salt should be used.
compartment A: Washing detergent
compartment B: Pre-wash detergent
1. Open cover C by
pressing button D.
2. Pour in the detergent
after consulting the
Wash
cycle table
:
• for powder detergent
use compartments A and
B
• for tablets, use
compartment A and the
bottom of the appliance,
i.e. when the
cycle requires 1 tablet, place it in compartment A
and close the cover; when it requires 2, place the
second tablet at the bottom of the appliance.
3. Remove detergent residues from the edges of the
compartment and close the cover until it clicks.
A
B
D
C
Start-up and use
* Only available in selected models.
Starting the dishwasher
1. Turn the water tap on.
2. Open the door and press the ON/OFF button: the
indicator light will illuminate.
3. Measure out the detergent (see below).
4. Load the racks (see Loading the racks).
5. Select the programme by pressing the WASH
CYCLE SELECT button; the corresponding indicator
light will illuminate.
6. Start the wash cycle by shutting the door: the
machine will emit a confirmation beep.
7. At the end of the cycle two short beeps will sound
and the WASH CYCLE indicator light will flash. Open
the door, switch off the appliance by pressing the
ON/OFF button, shut off the water tap and unplug
the appliance from the electricity socket.
8. Wait for a few minutes before removing the
crockery, in order to avoid burns. Unload the racks,
beginning with the lower level.
Modifying a wash cycle in progress
If a mistake was made during the wash cycle
selection process it is possible to change the cycle,
provided that it has only just begun: open the door,
taking care to avoid the escaping steam, and press
the WASH CYCLE SELECT button, holding it for 4
seconds. After one long beep and three short
beeps, the WASH CYCLE indicator light will switch
off: select the new wash cycle and start the
programme by shutting the door.
Adding extra crockery
Open the door, taking care to avoid the escaping
steam, and place the crockery inside the
dishwasher. Close the door: the cycle starts from the
point at which it was interrupted.
Accidental interruptions
If the door is opened during the wash cycle, or if
there is a power cut, the cycle stops. It starts again
from the point at which it was interrupted once the
door has been shut or the electricity supply is
restored.
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Indesit di 650 a at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Indesit di 650 a in the language / languages: English, French, Italian as an attachment in your email.

The manual is 2,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info