• Helps to avoid detergent residues in the laundry
by extending the rinse phase.
• Particularly suitable for washing baby laundry,
for people suering from allergies and for areas
with soft water.
“Energy Saver” button
• Saves energy used for water heating while
maintaining good wash result.
• Recomentable for lightly soiled laundry without
stains.
• Make sure that your detergent is suitable for
cold wash temperatures (15 or 20 °C).
• Mainly selectable on the lowest temperature
step of the programmes.
“Spin Speed” button
• Every programme has a predened spin speed.
• Press the button to set another spin speed.
• If spin speed “0” is selected, the nal spinning is
cancelled but intermediate spin peaks remain
during the rinse. The water is drained out only.
START DELAY
To set the selected programme to start at a later
time, press the “Start delay” button to set the
desired delay time. The lamp for the “Start delay”
option button lights up, and it goes o when the
programme starts. Once having pressed the “Start/
Pause” button, the countdown of the time delay
begins. The time delay indication on the display
disappears when the programme starts and it
is replaced by the remaining programme time.
Number of hours preselected can be reduced by
pressing the “Start delay” button again. Do not
use liquid detergent when activating this option.
To cancel the “Start delay” turn the programme
selector to another position.
PROGRAMME START
Open the tap and press the “Start/Pause” button.
The blinking light next to the “Start/Pause” button
becomes constant. The programme sequence
indicator shows the current programme phase,
running from left to right through Wash, Rinse,
Spin/Drain. When the programme phase is nised,
the corresponding indication goes out.
“LID LOCKED” INDICATION
After start of a program the lamp lights up to
indicate that the lid can not be opened. As long
as a wash programme is running, the lid remains
locked and must on no account be forced open.
In case you have an urgent need to open it during
a running programme, refer to “Cancel a running
programme before the end”.
FAILURE INDICATIONS
In case of any failures or irregularities, consult the
“Troubleshooting Guide” in your Instructions for Use.
“Water tap closed” -
No or not sucient inlet water.
“Service” -
Failure or malfunction of an electrical component.
“Clean pump” -
Waste water is not pumped out.
Spin speed indication blinks: unbalance during
spinning.
1.
PREPARATION OF THE WASH CYCLE
Load the washing machine, close the drum door
and check that it is closed properly.
2. Pour in the detergent and any additives, as
described overleaf and in the instruction
manual.
3. Close the lid.
4. Turn the programme selector to the desired
programme and temperature. The time display
shows the duration of the chosen programme
(in hours and minutes), and the lamp next to the
“Start/Pause” button ashes. The indication
lamp of the predened spin speed lights up. If
you do not start the programe soon after having
made your choice, the washing machine will
switch o automatically after about a quarter of
an hour. Switch on the washing machine again
by turning the programe selector back to ”O“
and then to the desired programe.
SELECT ANY DESIRED OPTION
When the combination of programme and
additional option(s) is not possible, the indication
lights switch o automatically. Unsuitable
combinations of options are deselected
automatically.
“Prewash” button
• Only for heavily soiled loads (for example
sand, granular dirt). Increases the cycle time by
approximately 19 min.
• Do not use liquid detergent for the main wash
when activating the Prewash option.
•
PROGRAMME END
The “Lid locked” indication lights o. After about
a quarter of an hour, the washing machine will
switch o completely to save energy.
1. Turn the programme selector to the “O”
position.
2. Close the water tap.
3. Open lid and drum and unload the machine.
4. Leave the lid open for some time to allow the
interior of the machine to dry.
1.
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
Press the “Start/Pause” button to pause the
programme. The light blinks.
2. Select the new programme, temperature, any
options and another spin speed if you want.
3. Press the “Start/Pause” button again. The new
programme continues at the same position
where the previous programme was interrupted.
Do not add detergent for this programme.
CANCEL A RUNNING PROGRAMME BEFORE THE END
The “Reset/Drain” button cancels a programme
before the end.
• Press the “Reset/Drain” button for at least 3
seconds. The water is drained out; it may last a
while until you can open the lid.
Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with
respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.Water and energy consumption refer
to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data.
The programme duration may dier from the values indicated above as it depends on the operation conditions applicable at that time (see also
“Troubleshooting Guide” in your Instructions for Use).
Approximete remaining moisture content (%). After programme end and spinning with maximum selectable spin speed, in default programme setting.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
** Reference Programmes for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.
Programme
Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration (hrs : min)
%
Turn & Wash303.5430.400:45
Synthetics403.0500.561:5040
Cotton407.0640.993:00
64
Cotton607.0521.332:35
Cotton907.058*2.102:35
Eco Cotton ** 607.0480.904:00
62
Eco Cotton ** 603.5340.752:50
Eco Cotton **407.0480.752:45
Eco Cotton ** 403.5340.652:30
Wool201.0400.100:35
Delicates301.5500.500:45
Colours403.5400.470:59
Cotton303.5420.250:30
Synthetics303.0400.310:50
CONSUMPTION DATA
Power consumption in o-mode 0.11 W / in left-on mode 0.11 W
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Indesit BTW D71253 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Indesit BTW D71253 in the language / languages: English as an attachment in your email.
The manual is 1,04 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
