669832
27
Zoom out
Zoom in
Previous page
1/45
Next page
ESCs - The 12/16A Vortex ESC
Overview
The ESCs used in the Vortex are a full-custom design, which uses a potent 32-bit ARM
processor.
Their diminutive 9.4mm width allows them to be inserted into the carbon fiber arms of the
Vortex, where they are fairly well protected against the elements, and from physical damage
from passing tree-branches.
The ESCs come pre-configured for all motors supported by the Vortex, and they have also
been used successfully with various after market motors used by our test team.
NOTE: The first generation of EzESCs cannot have their firmware upgraded by end-users.
Upgrading them requires special equipment, used in the factory, and at ImmersionRC
repair centers.
RotorSENSE
A unique feature of the ESCs used in the Vortex is RotorSense.
This feature puts an end to the decade-old ‘wire-swapping’ technique used to get brushless
motors to spin in the correct direction.
Once props are installed, at power-up before arming the flight controller, a simple spin of a
prop will program the rotation sense.
NOTE: This procedure may be performed with props in place, or props removed. For
safety’s sake it is recommended that props are removed.
If they are left installed, it is recommended to use a stick, or other object instead of a
finger to flick the prop.
The full procedure is as follows:
1) Cycle power to the quad to ensure that the flight controller is not armed.
2) Spin the motor in the desired direction. If the ESC recognizes the spin, two short beeps
will be generated.
3) Spin the motor again in the desired direction. If the ESC recognises the spin, 5 longer
beeps will be generated and the ESC has learned the direction.
27
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ImmersionRC Vortrex 285 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ImmersionRC Vortrex 285 in the language / languages: English as an attachment in your email.

The manual is 12,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ImmersionRC Vortrex 285

ImmersionRC Vortrex 285 Quick start guide - English - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info