669827
62
Zoom out
Zoom in
Previous page
1/65
Next page
The FatShark ‘GoPro’ lens (product ID 1752) increases the FOV of the stock camera, and
makes it much more suitable for racing, and freestyle.
If instead a CCD replacement is preferred, the common HS1177 (available under several
names from different manufacturers) is a good choice.
Note that due to the built-in OSD function, this camera has 4, instead of the stock 3 pins on
the connector. The standard cable may still be used however, using the 3 pins on one side of
the connector, ensuring that the Vid/Gnd/5V pins match the stock cable (Red = 5V, Black =
Gnd, White = Vid).
Q. The bell on one of my motors worked loose
With the first batch of 250 Pros that were produced, our motor supplier did have a quality
issue, where there was a chance that the motor bell could work loose during flight.
These motors are being replaced under warranty, just send an email to
repairs@immersionrc.com including a photo of the motor and bell.
Q. My vortex beeps continuously
The beeps are coming from the ESC’s. They start to beep when they don’t receive any PWM.
If all the ESC’s are beeping; it’s probably a flight-controller issue, in that case try to reflash it
with Cleanflight-Configurator. Check also the fusion board is still powered as +5V regulator
may be damaged.
If only one ESC is beeping; it’s probably a HW issue, so in that you will have to check wiring for
this ESC.
Q. My vortex is playing Crazy Train song
The tunes is emitted by ESC when overvoltage is detected (> 17.4 V). For the 20A ESCs, the
maximum voltage tolerated is that supplied by 4s HV LiPo packs.
Note that if the ESC gets wet, it can cause it to believe that an overvoltage condition exists.
Q. My vortex emits 2 long beeps followed by a short beep on startup (‐‐·)
This sequence is played on startup when the vortex was not able to detect a camera.
In that case you should check the camera is correctly plugged on both side.
62
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ImmersionRC Vortex 250 Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ImmersionRC Vortex 250 Pro in the language / languages: English as an attachment in your email.

The manual is 3,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ImmersionRC Vortex 250 Pro

ImmersionRC Vortex 250 Pro Quick start guide - English - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info