669827
13
Zoom out
Zoom in
Previous page
1/18
Next page
NOTE: Use the value displayed beside the bar to adjust the endpoints of your R/C transmitter
to have min@1000, center@1500, and max@2000. This is critical for correct OSD and
flight-controller operation.
NOTE: To restart the wizard at
anytime, power up the quad, press
and hold the button on the led
board until vortex beeps 2 times
(first beep after ~3 seconds,
second beep after ~5 seconds).
Alternatively you can also enter tx
Wizard via OSD menu
Once the wizard is finished,
various Cleanflight settings will
be configured, including enabling
oneshot, motor_stop, and
failsafe.
Another setting which is automatically made is the assignment of CH5 to the flight mode, Acro,
Horiz, and Angle. To complete the setup, configure your R/C Tx to link CH5 to a 3-position
switch.
Ensure that the switch correctly switches between the three flight modes, reflected in the
top-right corner of the OSD main landscape .
Note that It is highly recommended to attempt the maiden flight in either Angle, or Horiz mode.
Acro takes a little getting used to.
NOTE: Even though the flight controller failsafe has been set by the wizard, it is important to
also set the R/C Rx failsafe.
see https://github.com/cleanflight/cleanflight/blob/master/docs/Failsafe.md for cleanflight
specific failsafe test procedure.
On the EzUHF this is as easy as setting the controls in a ‘safe’ position (very low throttle for
example) and holding down the bind button on the EzUHF Tx until a beep is heard.
Flyaways with mini-quads are almost always caused by incorrect failsafe settings!
13
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ImmersionRC Vortex 250 Pro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ImmersionRC Vortex 250 Pro in the language / languages: English as an attachment in your email.

The manual is 2,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ImmersionRC Vortex 250 Pro

ImmersionRC Vortex 250 Pro User Manual - English - 65 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info