647440
26
Zoom out
Zoom in
Previous page
1/66
Next page
INSTRUCTIONS FOR USE OF THE ELECTRIC PLATE
The vitreous ceramic electric plate (5) is controlled by a knob (as above energy regulator). A pilot light
comes on as soon as the heating element is activated. The control knob is graded from 0 to 12. Position 0
indicates that the corresponding cooking area is switched off. Position 1 indicated that the corresponding
cooking area is at the minimum power, while position 12 indicates that the cooking area is at maximum
power.
The energy regulator controls the cooking area with two circuits (5). When the knob is turned clockwise
from position (off) to the desired position (1-12), the primary part of the cooking area is switched on. To
switch on the secondary part, turn the knob to position 12 and then turn it past position 12 as far as it will
go in a clockwise direction. At this point the secondary circuit switches on too and it is possible to vary
the power from 1 to 12 (1 = minimum, 12 = maximum)
RESIDUAL HEAT WARNING LIGHTS
Important: The ceramic hob cooking surface remains hot for a long time after use. Do not touch the hob
with your hands or let children near it. The residual heat indicator (Q) will remain lit until the hob has cooled
down.
If any cracks appear in the ceramic hot, disconnect the appliance immediately from the mains and call an
authorised technical service centre
ELECTRIC HOTPLATE
For efficient use and low energy consumption, it is advised to use pans specifically designed for electric
cooking on ceramic hobs. The bottom of the pan must be thick and flat. Its diameter must be as similar as
possible to that of the cooking ring. The surface of the hob and the bottom of the pan must be kept clean.
A – Do not leave the hotplate switched on without a pan
B – Do not wet or overheat the plates
C – Avoid sudden changes of temperature on the ceramic hob. For example, do not pour cold water onto
the hot hob.
ceramic electric hot plate
freestanding cookers
26 ILVE Freestanding Operating Manual
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ilve PD70 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ilve PD70 in the language / languages: English as an attachment in your email.

The manual is 3,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info