647427
41
Zoom out
Zoom in
Previous page
1/66
Next page
BEFORE CONNECTING THE PLUG INTO THE POWER SOCKET, FOLLOW THESE INSTRUCTIONS
The electrical supply for the upright cooker must be a 230 - 240 volt 50 Hz. The fuse and electrical wiring
of the home / premises must support the load of the appliance. The wiring used to connect the electricity
must be of a suitable size to carry the current load as specified on the product compliance plate. The
range must be connected to a suitable earthed power supply of sufficient capacity to meet the power
requirements as specified on the compliance plate. The power supply to the appliance must not be
subject to direct heat and must be positioned to prevent it coming in contact with the rear cover of the
range so that its temperature does not exceed 75°C
ANTI TILT BRACKET
Two Anti tilt Brackets are supplied with the product (see pictured below). These brackets are to be secured
to the rear wall 5 mm below the final height of the hob, when the product has been located and leveled,
mark the rear wall with a pencil to confirm the height of the hob. Locate the studs in the rear wall and
screw the anti tilt bracket so the top of the bracket is 5 mm below the hob line that has been marked on
the rear wall. For brick or concrete walls use the wall plugs that are supplied. Once the brackets have
been fixed in place, push the cooker back against the brackets then lift up the rear of the cooker so that
the bracket will lock under the rear lip of the hob.
electrical connection
freestanding cookers
41ILVE Freestanding Operating Manual
41


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ilve M-120 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ilve M-120 in the language / languages: English as an attachment in your email.

The manual is 3,21 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info