311706
2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 512 10049
Programme
Temperature
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 95 4,5 63* 1,80 2:05
Cotton 60 4,5 55 0,95 2:05
Cotton 40 4,5 55 0,55 2:05
Mixed Cotton/Synthetic 60 2,0 56 0,80 1:30
Synthetic 40 2,0 56 0,40 1:05
Delicate 40 1,5 60 0,55 0:45
Wool 40 1,0 60 0,50 0:40
Silk 30 1,0 60 0,30 0:50
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the
dispenser to no more then the “MAX” level
mark, as follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3. Turn the programme selector knob to the
desired programme.
4. Turn the temperature selector knob to the
desired temperature.
5. Turn the spin speed selector knob to the
desired spin speed. If the spin speed “ ” is
selected, the final spin is cancelled, but not the
intermediate spins. The programme ends with
a drain cycle.
CONSUMPTION DATA
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values
in the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
PROGRAMME START
Turn on the tap and press the “On/Off” button .
The indicator light of the “On/Off” button lights
up.
Note: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
END OF WASH CYCLE
The programme selector knob is in the Stop
position.
1. Press the “On/Off” button to switch off
the machine.
2. Cancel the option.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drum doors and unload
the machine.
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
1. Switch off machine by pressing the “On/Off”
button .
2. Select the new programme.
3. Start programme by pressing the “On/Off”
button again.
PAUSE/INTERRUPT A PROGRAMME
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the “On/Off” button .
2. After the desired pause, press again the
“ON/Off” button .
CANCEL PROGRAMME
1. Switch off the machine by pressing the
“On/Off” button .
2. Set the programme selector to “Drain” .
3. Press the “On/Off” button again to start
the “Drain” programme .
Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.
“Half Load” button
Reduces the water consuption in the “Cotton”
and “Synthetics” programmes especially during
the rinse.
Especially suitable for lightly soiled or small
loads (reduces the quantity of detergent).
Not suitable for high temperature programmes.
Ignis is a registered trademark of Whirlpool USA.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ignis awv 910 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ignis awv 910 in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ignis awv 910

Ignis awv 910 User Manual - English, Dutch - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info