305679
2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 100 01058
Programmes with prewash last about 15 minutes more than programmes without prewash. Water and energy
consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual
consumption may vary in comparison with the values specified in the table, because of differences in supply water
pressure and temperature, the load and the type of wash.
ADDING DETERGENT AND ADDITIVES
Pour the detergent and additives into the respective
compartments as follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and starch
Bleach
Stain removers
Anti-scale agents (water hardness 4)
Important Note:
Do not fill beyond the
MAX
level mark.
For programme with prewash: do not use liquid
detergent.
For programmes without prewash from cold to 40° C, it is recommended to use a liquid
detergent to avoid whitish residues on the coloured laundry.
CLOSE THE DOOR AND SELECT THE PROGRAMME
1. Turn the
programme selector knob
clockwise to the desired programme.
2. Turn the
temperature knob
to the required temperature.
3. Turn the
spin speed knob
to the required spin speed.
PRESS ANY DESIRED OPTION BUTTON(S)
Eco button
The wash time is extended and the water temperature is reduced.
This function saves about 30% in energy without compromising the excellent results of
the wash.
Intensive Rinse button
The water level increases for improved rinsing efficiency.
This option is particularly suitable for areas with very soft water when washing baby
linen and helps people with allergies.
For improved garment care it is advised to use the option for the Cotton 90° C and the
Coloured 60 °C programme.
Half Load button
Reduces the water consumption in the Cotton and Synthetics programmes
especially during the rinse.
Especially suitable for lightly soiled or small loads (reduces the quantity of detergent).
Not suitable for high temperature programmes.
Rinse Hold button
The laundry remains in the last rinse water, without progressing to the spin cycle to
avoid creasing and prevent colours from changing.
This option is especially recommended for the Synthetics or Delicate programmes.
This option is perfectly suitable if you wish to postpone the spin or you dont wish to
spin the clothes.
Note:
the programme selector stops on .
Terminate the Rinse Hold option
Press the Rinse Hold button again; the programme will terminate automatically with
the spin cycle corresponding to the previously selected wash programme.
If you do not wish to spin the clothes, switch off the appliance by pressing the On/Off
button. The pilot light goes out. Turn the programme selector to the Drain position and
switch on the appliance.
PROGRAMME START
Open the water inlet tap and press the On/Off button. The pilot lamp lights up.
DOOR LOCK
During the running programme, the door cannot be opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical power failure occurs, the door unlocks
automatically after about 1 minute.
PROGRAMME END
The programme selector knob is at STOP.
1. Press the On/Off button. The pilot light goes out.
2. Cancel the options by pressing the appropriate buttons.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload the machine.
SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER
PROGRAMME START
1. Press the On/Off button to switch off the appliance.
The pilot light goes out.
2. Select the new programme, temperature, spin speed and options.
3. Press the On/Off button to switch on the appliance.
The pilot light lights.
TO STOP, RESET A PROGRAMME BEFORE THE END
1. Press the On/Off button to switch off the appliance.
The pilot light goes out.
2. Set the programme selector on Drain.
3. Press the On/Off button to start the Drain programme.
Only open the door when the programme selector is at STOP and
the door is unlocked (after approximately 1 minute).
ENERGY AND WATER CONSUMPTION DATA
Programme Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
Cotton + Intensive Rinse 90 5.0 72 1.80 115
Cotton 60 5.0 66 1.15 115
Coloured + Intensive Rinse 60 2.0 66 0.80 100
Coloured 40 2.0 60 0.40 100
Rapid + 1/2 Load 40 2.5 54 0.50 85
Synthetics + 1/2 Load 30 1.0 54 0.30 70
Delicate 40 1.5 70 0.65 55
Wool 40 1.0 70 0.55 45
GB
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ignis awv 808 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ignis awv 808 in the language / languages: English as an attachment in your email.

The manual is 0,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ignis awv 808

Ignis awv 808 User Manual - English - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info