806370
15
Zoom out
Zoom in
Previous page
1/92
Next page
15
If there is water in the lower part of the refrigerator,
Check if:
TThe drain hole for the water is not clogged (use the defrost drain plug to clean the drain hole).
If your fridge is not cooling sufficiently:
Your fridge is designed to operate in the ambient temperature intervals stated in the standards,
according to the climate class stated on the information label. We do not recommend operating
your fridge out of stated temperatures value limits. This will reduce the cooling efficiency of the
fridge.
Recommendations
Unplug the refrigerator during a power cut in order to prevent any damage to the compressor.
Wait 5-10 minutes before plugging the appliance in once power returns.
If you unplug your refrigerator for any reason, wait al least 5 minutes before plugging it in. This
will avoid damage to the refrigerator’s components.
The cooling unit of your refrigerator is hidden at the rear of the appliance. Therefore, water
droplets or icing may occur on the rear surface of your fridge due to the operation of the
compressor at specified intervals. This is normal, there is no need to perform a defrosting
operation unless the icing is excessive.
If you do not intend to use your fridge for a long period of time (e.g. in summer holidays), put
the thermostat to “•” position. After defrosting, clean your fridge and leave the door open to
prevent humidity and smells.
If a problem persists after you have followed all the instructions above, please consult the nearest
Authorised Service Centre.
The appliance you have purchased is designed for domestic use and can only be used for the
stated purposes. It is not suitable for commercial use. If the consumer uses the appliance in a
way that does not comply with this, we emphasise that the manufacturer and dealer will not be
responsible for any repair or failure within the guarantee period.
Tips for saving energy
1. Install the appliance in a cool, well ventilated room , but not in direct sunlight and not near a heat
source (radiator, cooker.. etc). Otherwise use an insulating plate.
2. Allow warm food and drinks to cool down outside the appliance.
3. W hen thawing frozen food, place it in the refrigerator compartment. The low temperature of
the frozen food will help to cool the refrigerator compartment when it is thawing. This will help
to save energy. If the frozen food is put out, it results in a waste of energy.
4. Cover drinks or other liquids when placing them in the appliance Otherwise humidity increases
in the appliance. Therefore, the working time gets longer. Also covering drinks and other liquids
helps to preserve smell and taste.
5. Try to avoid keeping the doors open for long periods or opening the doors too frequently as
warm air will enter the cabinet and cause the compressor to switch on unnecessarily often.
6. Keep the covers of the different temperature compartments (crisper, chiller ...etc ) closed
7. Door gasket must be clean and pliable. Replace gaskets if worn.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ignis ARL 12GS2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ignis ARL 12GS2 in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 47.06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info