506279
8
Zoom out
Zoom in
Previous page
1/27
Next page
6
The Safety instructions should be read through carefully before you use this tool.
CAUTION
Do not recharge the battery for longer than 12 hours.
Technical data:
Screwdriver: Speed: 180 min
-1
;
Chuck: = 6.35mm (plug);
Forwards/reverse switch to tighten /
take out screws.
Rechargeable batteries: 4.8 V;
Sound Pressure Level: L
pa
<70db (A);
Vibration: Acceleration: < 2.5 m/s
2
.
Recharger: Input power: 230VAC 50Hz;
Class II Protection against electric shock;
Moisture protection (IP20);
Power: 6Vdc 300mA.
SAFETY INSTRUCTIONS
You should follow the safety instructions carefully to prevent damages or injuries to the
tool or the user, respectively.
1. If necessary, wear protective clothing (protective gloves, shoes, glasses, breathing
protection, etc.). Do not wear jewellery or loose clothing and if you have long hair, tie it up.
2. Before you replace parts or perform maintenance on the tool, make sure it is disconnected
from the power supply.
3. Keep your workplace clean and ensure for proper lighting.
4. Keep the tool in a dry location that is far enough away from heat and dangerous gases.
Do not use the tool near explosive substances or lightly flammable materials.
5. The surrounding conditions should adapted to fit the tool and the task. This is a household
tool and should only be used as such. Do not use this tool for heavy duty work.
6. In order to prevent danger, the drill should not be used when other persons, especially
children, are in the immediate vicinity. During and after operation, please keep children
away from this tool.
7. This device is not intended to be used by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the device by a person
responsible for their safety.
8. Children should be supervised at all times to ensure that they do not play with the device.
9. Make sure you have a good, solid foothold when using this cordless screwdriver. Many
accidents are caused by stumbling and falling.
10. If you drill into metal plates, you should use clamps or a vice. Secure the metal plates well
onto a firm base or in the vice. Place a piece of wood under the metal to be able to drill
through it without damaging the base underneath. Keep in mind that the metal plates
could turn with the tool, causing serious cuts.
11. Make sure that there are no live wires around your workplace.
12. Prior to drilling, check the walls for cables (a metal detector may also be used). Do not
touch the chuck, the socket or the drill bit.
13. Do not try to take apart the drill itself or the recharger. Only qualified professionals may
service the drill.
14. Should the recharger (the hull, cable or plug) be damaged, have it immediately replaced
through customer service. Do not use any other adapter other than the one supplied.
15. This tool does not need to be serviced additionally. The same applies for the electrical
parts.
16. Before you clean the plastic parts, you should disconnect the tool from the power supply.
To clean the tool, use a damp cloth and a mild cleanser. Never immerse this tool or its
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ideen Welt SD0018 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ideen Welt SD0018 in the language / languages: English, German, Polish as an attachment in your email.

The manual is 0,56 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info