3
NOTE: the flame may not be visible to the naked eye in daylight and must be cool before filling.
• NEVER refill over or near an open flame and use a decanter with a flame arrestor only.
• Remove all plastic & packaging before using the Burner.
Trouble shooting and operating tips:
• The hooks on the back of the Sliding Lid Handle can be used to carry the Slimline Burner
by hooking it around the slotted openings in the Vent Plate as shown in the image
below. Not Applicable to Round Burner.
• The first fill will take longer and more fuel as the material inside the Fuel Tank will absorb
the fuel. Subsequent filling should be quicker with less fuel. Take care to not fill the burner
at a faster rate than what the material inside can absorb.
• If the fire does not extinguish the first time by closing the Sliding Lid follow these steps and
repeat if necessary.
o Check that the surface below the sliding plate is clean and free from
obstruction.
o Apply strong downward force and in one quick motion move the sliding plate
towards the closed position. If the flame is still visible repeat this step as a
double motion still applying strong downward force in quick succession.
• Never blow on the flame whilst the Sliding Lid is in an open position.
• If your Slimline Burner does not ignite after it has been closed overnight pour a small
amount of fuel across the length of the Burner Vent with the supplied plastic bottle and
introduce the flame. This should then ignite the stagnant fuel inside the Fuel Tank. For
Round Burner simply add fuel to the tank and ignite.
• VERY IMPORTANT: Take special care when adding fuel to the Slimline Burner, always
close the Sliding Lid for a few minutes before adding fuel to make sure there is no visible
flame in the Burner Vent.
• If after some time you find the Sliding Lid has become ‘sticky’ when attempting to move
it then remove the Sliding Lid from its housing and rub the underside using the green side
of a Scotch Bright scouring pad. Take care to only scrub in the direction of the brushing
lines of the stainless steel. Not applicable to Round Burner.
• Make sure you keep your Burner clean especially the surface that the Sliding Lid slides on
and ensure that any excess fuel on the surface of the Burner is wiped off before use.
