12824
37
Zoom out
Zoom in
Previous page
1/80
Next page
21
5
REPEATER OPERATION
4
5
General
When using a repeater, the transmit frequency is shifted from the
receive frequency by the offset frequency. It is convenient to pro-
gram repeater information into memory channels.
q Set the receive frequency (repeater output frequency).
w Push [A
FUNC
], then push [4
DUP
] several times to select “–” or
+.
“–” indicates the transmit frequency is shifted down; + indicates
the transmit frequency is shifted up.
Blinking “–” or + indicates the reversed duplex mode is selected in
SET MODE
(p. 48).
e Push [A
FUNC
], then push [1
TONE
] to activate the subaudible
tone encoder, if required.
•“ appears
Select the desired subaudible tone frequency, if necessary. (p. 22)
r Push and hold [PTT] to transmit.
The displayed frequency automatically changes to the transmit fre-
quency (repeater input frequency).
If OFF appears, check the offset frequency (p. 22) and direction.
t Release [PTT] to receive.
y Push and hold [SQL] to check whether the other stations trans-
mit signal can be directly received or not.
About reversed duplex mode
When the reversed duplex mode is selected, the receive fre-
quency shifts. (Transmit frequency shifts in normal duplex mode.)
Each receive and transmit frequency is shown in the table below
with the following conditions;
Inputed freq.: 145.30 MHz
Direction : (negative)
Offset frequency : 0.6 MHz
Reversed OFF ON
Rx frequency 145.30 MHz 144.70 MHz
Tx frequency 144.70 MHz 145.30 MHz
IC-V8_New.qxd 03.2.6 10:20 Page 21 (1,1)
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-V8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-V8 in the language / languages: English as an attachment in your email.

The manual is 1,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info