458646
37
Zoom out
Zoom in
Previous page
1/80
Next page
26
6
SCAN OPERATION
New2001
6
Full/band/programmed scan
qSelect VFO mode with [V/MS.MW~].
Select the desired frequency band with [BAND ], if desired.
wSet the squelch to the point where noise is just muted.
ePush [MODESCAN] for 1 sec. to enter scanning type se-
lection condition.
rRotate [DIAL] to select the desired scanning type.
•“ALL for full scan; BAND for band scan, PROGxx for pro-
grammed scan (xx= 0 to 24; programmed scan edges numbers
only displayed)
tTo start the scan, push [MODESCAN].
Scan pauses when a signal is received.
Rotate [DIAL] to change the scanning direction, or resumes
manually.
Push [MODESCAN] again to stop the scan.
NOTE: Instead of the steps e to t operations, while
pushing and holding [MODESCAN], rotate [DIAL] to se-
lect the desired scan type. In this case, scan starts when
releasing [MODESCAN].
About the scanning steps: The selected tuning step in
each frequency band (in VFO mode) is used during scan.
FM SKIPPFM SKIPP
During full/band scan During programmed scan
[MODESCAN]
[DIAL]
Full scan selection
Band scan selection
Programmed scan selection
Selectable between 0 to 24
if programmed
IC-R5_1.qxd 02.10.23 11:29 Page 26 (1,1)
37


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-R5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-R5 in the language / languages: English as an attachment in your email.

The manual is 3,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info