90
7
SCAN OPERATION (Multi-function receiver/Component screens only)
■ Scan resume condition
When receiving a signal, scanning automatically pauses on
that signal. The scan resume condition sets the time that the
scan pauses before resuming or whether scan stops instead
of pausing.
qClick the zSETx button to call up the [Scan Delay] screen if
it is not displayed.
wSelect the scan delay condition from ‘Pause until Signal
Disappears,’ ‘Delay Volume’ or ‘Scan Stop.’
(a) ‘Pause until Signal Disappears’
Scan pauses when receiving a signal and remains
paused until the signal disappears.
(b) ‘Delay Volume’
When setting a delay time using the [DELAY] control
(on [Receiver] screen or Component screen), scan
pauses when receiving a signal and then resumes after
the specified delay.
(c) ‘Scan Stop’
When a signal is received during scan, scan stops and
does not resume.
eSelect a restart delay time in [Restart Delay]. This setting is
valid when (a) or (b) is selected in step w.
• 0 Sec. : Scan resumes immediately after the signal dis-
appears.
• 1 Sec. : Scan resumes 1 sec. after the signal disappears.
• 2 Sec. : Scan resumes 2 sec. after the signal disappears.
rClick the close ([X]) button to close the setting screen.
