670378
10
Zoom out
Zoom in
Previous page
1/40
Next page
5
New2001New2001
PANEL DESCRIPTION
3
Front, top and side panels
q LOCK KEY [ ]
Hold down for 1 second to lock or unlock the keypad.
L Push to use the pre-assigned function. Ask dealer for details.
w PTT SWITCH [PTT]
Hold down to transmit, release to receive.
e CHANNEL 16/CALL CHANNEL KEY [16/C] (p. 11)
z Push to select Channel 16.
z Hold down for 1 second to select the Call channel.
r SQUELCH ADJUSTMENT KEY [SQL] (p. 14)
z Push to enter or exit the Squelch Adjustment mode.
z Hold down to open the squelch, to monitor the channel.
t TRANSMIT POWER KEY [H/L]
z Push to set the power level to high, mid, or low.
L Some channels are set to only low power.
z Hold down for 1 second to display the battery health
and battery cycle. (p. 18)
y FAVORITE CHANNEL KEY [FAV] (p. 16)
z Push to select a Favorite channel.
z Hold down for 1 second to set or clear the selected
channel as a Favorite channel.
u SCAN/DUALWATCH KEY [SCAN]/[DUAL]
z Push to start or stop a scan. (p. 15)
z Hold down for 1 second to start the Dualwatch.* (p. 17)
L While Dualwatch, push to cancel Dualwatch.
*Tri-watch may start, depending on the Set mode settings.
i WEATHER CHANNEL*/ CHANNEL GROUP KEY
[CH/WX]/[U/I/C/L]/[CH]
z Push to enter or exit the Weather Channel Selection
mode.* (p. 12)
*Except the European, UK, and German versions.
z Hold down for 1 second to change the channel group. (p. 12)
o MULTI-CONNECTOR
Connects to an optional speaker microphone or headset.
!0 STATUS INDICATOR
z Lights red while transmitting.
z Lights green while receiving a signal, or when the
squelch is open.
!1 VOLUME/POWER SWITCH [VOL]
z Rotate to turn the transceiver ON or OFF.
z Rotate to adjust the audio output level.
!2 TUNING DIAL [DIAL]
z Rotate to select a channel.
!2
Antenna
Connector
q
w
y
e
r
t
Speaker
i
u
!1
Microphone
o
!0
10


Need help? Post your question in this forum.

Forumrules
1

Forum

icom-ic-m85

Reset search

  • Set transmit and shows RED after releasing PTT the status indicator shows Orange and channel blink for 5 sec and stop blinking of Channel. Transmission ok but no reception. Whats may be the problem Submitted on 25-7-2022 at 08:14

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-M85 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-M85 in the language / languages: English as an attachment in your email.

The manual is 2,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info