530914
45
Zoom out
Zoom in
Previous page
1/56
Next page
New2001
37
12
TROUBLESHOOTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
PROBLEM POSSIBLE CAUSE SOLUTION REF.
The transceiver does not
turn ON.
The battery is depleted.
• Bad connection to the battery pack.
• Recharge the battery pack.
• Check the connection to the transceiver.
pp. 33,
34
p. 3
No sound from the speak-
er.
• Squelch level is too tight.
Volume level is too low.
• Speaker has been exposed to water.
Water has entered to [SP MIC] connector.
• Set squelch to the threshold point.
• Rotate [VOL] to set a suitable level.
Hold down [F] to drain water from the speaker.
• Dry [SP MIC] connector.
p. 13
p. 11
p. 13
Transmitting is impossible,
or high power can not be
selected.
Some channels are for low power or receive
only.
The battery is exhausted.
The battery is overcharged.
The output power is set to low.
The transceiver is over heated.
• Change channels.
• Recharge the battery pack.
Verify the battery voltage is correct.
• Push [H/L•LOCK] to select high power.
Turn OFF the power, leave it at room temperature for
a while.
pp. 11,
12,
40–42
pp. 33,
34
p. 11
The displayed channel
cannot be changed.
• Lock function is activated. Push [H/L•LOCK] for 1 second to cancel the function. p. 12
Scan does not start.
Favorite (TAG) channels are not programmed.
• Set the desired channels as “Favorite (TAG)” channels. p. 15
No beeps. • Beep tones are turned OFF. Set the beep tones to ON (Fix Beep/Preset) in the SET
mode.
p. 26
Does not record or does
not record properly.
The read/write capacity has been exceeded
(the recording counter displays 100 or more.
(p. 4)), or the memory is damaged.
The memory IC should be replaced.
Ask your technical dealer for service.
The weak signal is not
recorded by the automatic
recording function.
The automatic recording threshold level is
too deep.
• Set the automatic recording threshold level to shallow. p. 30
“CHARGE” comment
blinks
The connected battery is depleted. • Recharge the battery pack. pp. 33,
34
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-M73 Euro at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-M73 Euro in the language / languages: English as an attachment in your email.

The manual is 5,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info