12652
56
Zoom out
Zoom in
Previous page
1/64
Next page
50
9 CONNECTIONS AND MAINTENANCE
New2001
Optional unit installation
CAUTION: DISCONNECT the DC power cable from the
transceiver before performing any work on the transceiver.
Otherwise, there is danger of electric shock and/or equip-
ment damage.
See the following the case disassembly procedure when you
want to install an optional unit.
q Remove the 12 screws and open the transceiver.
w Turn the transceiver upside down, then disconnect the 3
flat cables and Rear mic connector (6-pin) from LOGIC
board, and Front mic connector (2-pin) and Volume con-
nector (3-pin) from AF board.
e Install an optional unit to J3 on the AF board as shown
below.
r Assemble the units to their original positions.
CAUTION:
Tighten the screws with the specified torque (0.7 N.m)
when assembling the transceiver. Otherwise the trans-
ceiver may be damaged (torque too high) or lose water-
proof efficiency (torque too low).
When unistalling the optional unit, remove it vertically.
Wiggling the unit from side to side may damage the op-
tional unit's connector.
J3
AF board
Optional unit
Flat cables
LOGIC
board
Front mic
connector (2-pin)
Volume
connector
(3-pin)
Rear mic
connector
(6-pin)
AF board
!IC-M603.qxd 06.7.28 1:46 PM Page 50 (1,1)
56


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-M603 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-M603 in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info